GAE Optimizer EQX24 Manuel d'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} GAE Optimizer EQX24. GAE Optimizer EQX24 14 pages.

Be sure to read the following before connecting and operating this device for the first time:

- This unit contains no user-serviceable parts.

- There are no operating controls inside the unit. It is not necessary to open the unit for operation.

- Refer all repair and maintenance to authorised GAE service personnel.

- Tampering with the internal circuitry will void any guarantee claims.

- Be sure to allow for sufficient cooling during operation especially when rack mounting this unit

above other heat producing units (amplifiers etc.).

- The main fuse of this device is a maintenance-free PTC-resistor in the secondary circuit. The

primary circuit fuse provides an extra protection against a defect in this circuit. This fuse may

only be replaced with the specified type M0.25A (M= medium slow break) for 230V units.

(M0.5A for 15 - 120V USA-units)

- Ensure that the unit is protected from heat and humidity.

- Make sure that the power source voltage specified on the rear panel of the unit matches your

local AC mains supply.

(220-240V/50-60Hz European-units, 115-120V/50-60Hz USA-units)

- Only use good quality cable material when connecting this unit. This applies to both signal and

sense cables.

- Be aware that high voltages can occur in the sense cables.

- Read the operating manual carefully.

This document confirms that the product GAE Optimizer EQX24 bearing the CE label meets all re-

quirements in the EMC directive 89/336/EEC laid down by the Member States Counsel for adjustment

of legal requirements, further more the product complies to the rules and regulations referring to the

electromagnetic compatibility of devices from 30. August 1995.

This product bearing the CE label complies with the following harmonised or national standards:

DIN EN 55011; DIN EN 55013; DIN EN 50014; DIN EN 55022; DIN EN 60555; DIN EN 50081-1/2

The authorised declaration and compatibility certification lies with the manufacturer and can be viewed

on request. Responsible as manufacturer is the company:

opal audio vertrieb GmbH, Engerstraße 47, D-33824 Werther, ++ 49 5203-236/237 Fax 238

The awarding of the CE label confirms the compliance with legal directives issued for the manu-

facture and marketing of electronic and electrical devices. As such the CE label is not a „ seal of

quality" but rather proof that the device bearing the label is conform with the electromagnetic com-

patibility standards laid down in the above named testing regulations.

High volume levels can lead to irreversible hearing damage.

In cases where hearing becomes painful it is possible that damage is incurred within the whole

nervous system.

Modern sound systems are designed to reproduce high volume levels and as such can be consid-

ered a danger to human hearing when incorrectly operated.

Important

Reference to EC statement of conformity

WARNING