Gage Bilt GB705NAST Manuel - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Gage Bilt GB705NAST. Gage Bilt GB705NAST 8 pages. Hydraulic installation tool

Imprimer la page

DESCRIPTION

WARNING:

The balance of this tool is designed for horizontal use and is not ergonomically best suited

for all applications. Gage Bilt will be pleased to advise for your specific application.

GB705NAST

The

hydraulic installation tools designed specifically for the efficient installation of a wide

range of blind rivets and lockbolt fasteners thru 3/16" diameter. They weigh just over 3 lbs.

be operated in any position with one hand. They have a .500"

(25.9 kN).

load of 5825 lbs.

GB705NAST

The

installation tool operates on hydraulic pressure developed by the GB940 Powerunit set at

(393.0 bar)

5700 psi.

tool comes equipped with a 12' hydraulic hose with quick disconnects and a electric control cord assembly .

NOSE ASSEMBLIES ARE NOT FURNISHED WITH THE TOOL AND MUST BE ORDERED SEPARATELY.

MAINTENANCE

WARNING:

EXCESSIVE CONTACT WITH HYDRAULIC FLUID AND LUBRICANTS SHOULD BE AVOIDED.

WARNING:

MAINTENANCE PERSONNEL

WARNING:

DISCONNECT TOOL FROM ITS POWER SOURCE BEFORE PERFORMING MAINTENANCE.

WARNING:

BE SURE POWERUNIT IS DISCONNECTED BEFORE CLEANING OR WHEN REPLACING WORN

OR DAMAGED COMPONENTS. SEVERE PERSONAL INJURY MAY OCCUR IF POWER SOURCE

IS NOT DISCONNECTED.

The performance of any tool depends upon good maintenance practices. Following these minimal

requirements for service and care will extend the life of your tool.

*Only use a hydraulic power source equipped with relief valves and pressures set within

specified limits.

*Keep hydraulic system free of dirt. Avoid letting couplers contact a dirty floor.

*Do not use as a hammer to force fasteners into holes or otherwise abuse tool.

*Proper care by operators is necessary in maintaining full productivity and reducing downtime.

*Keep nose assemblies, especially jaws, clean and free of chips and debris. Lube jaws and collet surfaces

that jaws ride on with light machine oil on a daily basis.

*All Screwed End Caps, Base Covers, Air Fittings, Triggers, Screws and Nose Assemblies are to be

examined at the end of each working shift to check that they are secure.

*Check tool, all hoses and all couplings daily for damage or hydraulic leaks. Tighten or replace

(if necessary ).

HYDRAULIC THREAD PREPARATION

IMPORTANT:

Be sure to use thread sealant on all hydraulic fittings, Loctite® 30534 or similar Teflon® infused pipe

dope is recommended.

properly applied, pieces of Teflon may enter the hydraulic system and cause malfunction or damage.

Use 1 1/2 wraps of tape on each thread. Cut off all loose tape ends. Tighten until fitting feels snug and

then go 1/2 to a full turn past that point.

Note: Gage Bilt does not recommend using a pneumatic lubricator or adding pneumatic oil to the air inlet

on our tools or powerunits.

maximum PULL pressure and 2400 psi

CAUTION:

(12.7mm)

(165.5 bar)

MUST

READ AND UNDERSTAND ALL WARNINGS AND CAUTIONS.

Teflon tape is an excellent thread sealer, however, if it is not

CAUTION:

Over tightening can easily distort the threads.

(1.36kg)

rivet setting stroke and a rated pull

maximum RETURN pressure. The

and can

3/14