Gage Bilt GB740 Manuel d'installation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Gage Bilt GB740. Gage Bilt GB740 12 pages.
Également pour Gage Bilt GB740 : Manuel d'instructions original (20 pages)

Imprimer la page

OVERHAUL

The disassembly and re-assembly procedure can be accomplished by utilizing the following instructions and drawings. Use extreme

care during disassembly and re-assembly not to mar or nick any smooth surface that comes in contact with seals. Before installing

seals, always apply a good lubricant, such as Lubriplate®, to the surfaces. It is recommended that tool kit (GB740TK) be used to

facilitate overhaul. A complete overhaul can be achieved by the use of Service Kit 740002 which contains a complete set of o'rings,

back-up rings, screws, washers and gasket. It is recommended that this service kit be kept available for spare parts.

WARNING:

DEPRESS TRIGGER AND DISCONNECT FROM AIR WITH HEAD PISTON IN THE REAR POSITION BEFORE

OVERHAUL. SEVERE PERSONAL INJURY MAY OCCUR IF AIR HOSE IS NOT DISCONNECTED.

WHEN FORCING PISTON ROD ASSEMBLY DOWNWARD WITH HEAD CYLINDER ASSEMBLY REMOVED,

HYDRAULIC FLUID WILL EJECT FORCIBLY FROM HANDLE.

704214

STEM CATCHER BAG

HEAD

Remove nose assembly and adapter from tool before attempting disassembly of head assembly.

Remove end cap (740112). Push against threaded end of head piston (740308) to slide it out of head cylinder (740109). Be careful not

to damage threads or cause burrs on polished piston rod surface.

WARNING:

DISPOSE OF HYDRAULIC FLUID IN ACCORDANCE WITH ALL ENVIRONMENTAL LAWS AND REGULATIONS

APPLICABLE TO YOUR AREA..

The re-assembly sequence is the opposite of disassembly. (See Filling and Bleeding instructions.) Apply Loctite® #242 and torque

the button head cap screws (402479) uniformly to 40 inch lbs. to prevent leakage around the gasket.

401208

SOC. HD. CAP SCREW

740101

NOSE FITTING

401208

SOC. HD. CAP SCREW

704151

POWER CYLINDER TOOL

704149

PISTON ROD WRENCH

(704214 CATCHER BAG SHOWN ABOVE IS SOLD SEPARATELY)

GB740TK Service Tool Kit Includes:

704149

Piston Rod Wrench Assembly

704150

Packing Plug Wrench Assembly

704151

Power Cylinder Tool

704152

Seal Guide

S1178

Valve Extractor

744151

Valve Spring Installation Tool

744152

Valve Sleeve Removal Tool

740109

HEAD CYLINDER

S945 - O'RING

704152

SEAL GUIDE

704150

PACKING PLUG WRENCH

BLEEDER BOTTLE

S108 - BACK-UP RING

740308 - PISTON

S572

STAT-O-SEAL

402482 - BUT HD CAP SCREW

744151

VALVE SPRING

INSTALLATION TOOL

744152

704153

VALVE SLEEVE

REMOVAL TOOL

740112 - CAP

A-294 - O'RING

USE CAUTION

S1178

VALVE EXTRACTOR

400787 - O'RING

Rev. 3/13