Dyna-Glo RMC- 95C6 Manuel du propriétaire - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Dyna-Glo RMC- 95C6. Dyna-Glo RMC- 95C6 18 pages. Portable
kerosene-heater
Également pour Dyna-Glo RMC- 95C6 : Manuel du propriétaire (18 pages)
Imprimer la page
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
WICK ASSEMBLY- Check at least once a month!!
The burner assembly sits on top of the wick guide. Over time, tar deposits can
accumulate on the wick guide, and this can prevent the burner assembly from
seating properly. This can result in poor combustion, smoke, odor, etc.. To prevent
this from happening, tar deposits on the wick guide can be removed as follows:
Making sure that the heater is both cool and turned off, lower the wick to the "off" position.
Remove the batteries (located at the rear of the heater).
Remove the 2 cabinet screws. Lift off the cabinet and grill assembly as shown in
illustration. (Fig.A)
Using the wick adjuster knob, raise the top of the wick until it is even with the top
of the wick guide. Using a flat-edge screwdriver, scrape off the tar deposits.
Be careful not to allow any of the tar deposits to drop into the grooves of the wick
guide. A small vacuum cleaner can be used to remove the tar deposits that have
been scraped off. (Fig.B)
Reassemble the heater and replace the batteries.
WICK REPLACEMENT
The wick in your heater needs replacing if, after repeated cleanings, any of the following conditions still exist: slow to light,
hard movement of the wick adjuster knob, kerosene odor while burning, low heat output, slow warm up, damaged wick.
Use only a genuine replacement wick.
REPLACEMENT WICK NUMBER: Kero-World 32225, Dura Heat DH-145, Glowick 30856.
If cleaning the Wick does not improve performance, you will need to replace the wick. Refer to the "TROUBLE
SHOOTING GUIDE", see page 14, which outlines conditions under which the wick should be replaced.
DO NOT attempt to substitute any other type of wick device or a wick designed for another brand or
model heater. You could damage the heater and create a potential fire hazard.
Call customer service at 1-877-447-4768, to order a wick.
ATTENTION : The only tools needed to replace the Wick are :
A pair of pliers
Visit our website at: www.ghpgroupinc.com/heaters/faqs.aspx and select RMC-95C6 /RMC-95C6B for a link
to a detailed video demonstrating wick replacement.
1
. Push down the manual shut-off knob and turn the wick adjustment knob
COUNTERCLOCKWISE in the direction of "OFF".
4
. Gently pull the wick adjustment
knob off the heater.
A flat blade screwdriver
2
. Use a screwdriver to loosen and remove
cabinet screws on either side of the heater
cabinet.
3
. Use the carrying handle to lift the cabinet
straight up and away from the heater.
5
. Remove the cabinet base by
lifting it from the back and
tilting it forward to clear the
wick adjuster assembly.
9
Fig.A
Fig.B
A plastic bag with a twist tie
6
. Trip the pendulum on the
automatic safety shutoff
system to lower the wick.