GAGEMAKER PN-3000 Series Manuel d'utilisation - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} GAGEMAKER PN-3000 Series. GAGEMAKER PN-3000 Series 20 pages. Pin nose gages and seal diameter gages pin nose gages and seal gage operation manual
Imprimer la pagePin Nose Gages and Seal Gage Operation Manual
SETTING STANDARDS
The PNS-3000 pin seal diameter gage setting
standard is an adjustable standard used to preset
the PN-3000 series pin seal gages. The PN-3000
PNS-3000
gages use a dial indicator to compare a known
Pin Seal Gage
diameter to the diameter of the machined piece.
Setting Master
The PNS-3000 is adjusted to any diameter within
the range of the standard. The standard is easy to
setup and provides an accurate master on which
to null the PN-3000 indicator.
The PNS-3000 has two adjustable blocks that ride
on 2 precision ground rails. The upper block is
connected to a fine adjustment thumbscrew, the
lower block slides on the rails and is locked in
place with 2 setscrews located on the bottom of
the block.
The contact points of the PN-3000 gage contact
the hardened pads that are inset into the upper
and lower blocks. The setting dimension for the
standard is the dimension over these 2 pads.
PNT-3000 Taper Plates for PN-3001/2/3 Gages
Sizes not Listed are Available upon Costomer's Request.
PN-3000/T Pin Seal Standoff Plates (2 per set)
(See Page 6)
12