Dawnco STARLOOK- D Manuel - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Dawnco STARLOOK- D. Dawnco STARLOOK- D 16 pages.

3. Analog. Chose between KU-band and C-band (normal or inverted video).

4. Motor. Chose the type of actuator to be used; standard DiSEqC 1.2,

SatSelect or SATSCAN.

5. Display. submenu units: Select dB-presentation: dbuV,

Dbm or dBmV.

Under submenu LCD can contrast (level) and Backlite (on/off) be set.

6. AutoOff. Chose between some automatic turn-off alternatives (timer).

7. Version. Tells about the units serie-nr and manufactured date.

7. Beeper

It might be tricky to install a Sat-dish and, at the same time, try to watch the

signal-level on the instrument.

Therefore the instrument has a very useful "beeper"-function to help finding the

max-strength signal. It works with a pitch tone that gets higher and higher the

better the signal gets.

The beeper is turned on and off with button nr 7.

Notice that the function works with a narrow bandwith (one transponder) and

not with the full bandwidth.

To use the function: put the cursor on top of a selected "peak" and align the dish.

8. Spec

Special-functions. Select with button nr 8 in the Mainmenu.

1. Max hold

Max hold is a very good function for, over a longer time period, watch a certain

frequency-range. This to see how/if temporary signals/disturbances can affect the

picture quality.

Adjust the frequency-bandwidth (see Function 3) and put the cursor on the

frequency (peak) to watch. Chose with button nr 1 the "Max hold"-function. The

instrument starts to sample all top-values in the shown bandwidth and only

updates the presentation if there´s any new measured data with higher dB-values

than the previous measured.

Turn off the function by pressing the button nr 1 again (No hold).

Measured data can be stored. Read more about the Memory-function under section

4 below.

(9)