Great day UVFR751 Instructions pour l'installation et l'utilisation - Page 5
Parcourez en ligne ou téléchargez le pdf Instructions pour l'installation et l'utilisation pour {nom_de_la_catégorie} Great day UVFR751. Great day UVFR751 5 pages. Utv front rack
Imprimer la page
STEP 1:
INSTALL 1- 5/16" X 1 ¼" BOLT, 2 FLAT WASHERS AND LOCKNUT INTO MIDDLE HOLE OF THE LEFT AND
RIGHT ANGLE BRACKETS (BRACKETS WITH THREE HOLES ON ONE SIDE). TIGHTEN COMPLETELY.
NOTE: THIS BOLT WILL ACT AS A HORIZONTAL REST WHEN INSTALLED
FIG. 1
STEP 2:
REMOVE THE BOTTOM ALLEN BOLT SECURING ROLL BAR SECTIONS ON EACH SIDE OF POLARIS.
STEP 3:
INSTALL THE BRACKET TO EACH SIDE OF RANGER USING 1- 5/16" X 3 ½" BOLT AND 12 FLAT WASHERS
AND LOCKNUT.
NOTE:
10 OF THE FLAT WASHERS ARE TO BE USED BETWEEN ANGLE BRACKET AND ROLL BAR. THESE WILL
FILL THE VOID LEFT BY THE HEAD OF THE REMOVED ALLEN BOLT.
BOLT WILL PROTRUDE THROUGH INSIDE OF ROLL BAR. TIGHTEN ALL ASSEMBLIES. BRACKETS
SHOULD SIT HORIZONTAL TO THE GROUND
REFER BACK TO STEP 2 OF INSTRUCTION MANUAL FOR REMAINDER OF INSTALLATION
FIG. 3
SEE FIG.4
.
FIG. 4
. SEE FIG. 1 & 2
FIG. 2
SEE FIG. 3
Page 5
.