DAX HESSAIRE DX6800 Manuel d'instructions de montage - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de montage pour {nom_de_la_catégorie} DAX HESSAIRE DX6800. DAX HESSAIRE DX6800 8 pages. Rooftop evaporative coolers

Imprimer la page

S TEP # 5 B

(cabinet assembly, motor / motor bracket arms assembly, propeller, cover panel)

Tip back over to

install prop once

bottom cover

panel is securely

in place.

•

Cover Panel

Attaching Cover Panel

DX4800: Use 4 screws.

(ST6.3X19)

Hardware Bag: E

DX6800: Use 12 screws.

(ST3.9X13)

Hardware Bag: B

S TEP # 6

DAX Assembly Sheet 031023

As s e m b l e S i d e D r a f t P o s i t i o n

At t a c h W i r i n g B o x / C o n n e c t M o t o r & P u m p

(wiring box, assembled cabinet, cable ties)

•

Prop

•

ST3.9X16 Screws(2 ea):

Attach Junction Box To

Underside Of Top Lid.

(Hardware Bag C)

Assembly Notes:

While box is still disconnected, route wires from

both "quick connectors" through openings in box

leaving bare wire ends available for wiring to

thermostat.

Connect pump and motor "quick connector" ends

to the matching "quick connector" ends through

the junction box wall.

Attach box to underside of top lid using the correct

screws.

Use cable ties to secure pump and motor wires

out of path of propeller.

Assembly Notes:

Tip unit on side with side discharge

venturi panel facing down to make

installation of motor assembly easier.

Set ring down on venturi—lining up

holes in all 4 corners.

Place motor / motor arms assembly

on top of ring and bolt both motor

assembly and ring in place using the

same screws as down draft position

assembly shown above.

Attach cover panel to bottom side.

Model DX4800: Attach cover panel to

open venturi side using 4 screws

(ST6.3X19) to attach cover panel.

Model DX6800: Attach cover panel to

open venturi side using 12 screws

(ST3.9X13) to attach cover panel.

Tip entire unit back over so bottom

cover panel is down and unit is now

in side discharge position.

Install propeller. Tighten securely.

Ring (Held In Place Between

Motor Arms & Side Venturi Frame)

Junction Box

Quick

Connectors