Dynablast CRDG Series Manuel du propriétaire - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Dynablast CRDG Series. Dynablast CRDG Series 12 pages.
Imprimer la page
BASIC MAINTENANCE
WATER SCREEN
CAUTION: If the screen is not kept clean, the flow of
water to the pressure washer will be restricted and the
pump maybe damaged.
The pressure washer is equipped with a water inlet screen
to protect the pump. Clogging of the water screen will
restrict flow of water. Cleaning is immediately required
with unit turned OFF.
1.
Disconnect the garden hose from the INLET.
2.
Remove the water screen from the INLET.
3.
Clean screen under warm water.
4.
Replace screen immediately to prevent any foreign
matter from entering the pump.
5.
Reconnect the garden hose to the INLET.
CAUTION: Do not damage the screen while removing
or cleaning. Any foreign particles entering the pump will
damage the unit.
ENGINE
To ensure proper care of the engine, be sure to follow the
manufacturer's maintenance schedule, routine inspection
procedures and maintenance procedures.
Please refer to the Engine Owner's Manual for details on
maintenance of the engine.
WARNING: Improperly maintaining the engine, or failure
to correct a problem before operation can cause a
malfunction in which you can be seriously hurt or killed.
NOTE: In the unlikely event that you have a problem
with the engine, you must contact a Honda Service
Centre. Please call the Honda toll-free hotline at
1-888-946-6329 to locate the nearest Authorized
Service Centre.
8
(CONT'D)
PUMP OIL CHANGE
NOTE: Check the pump before every use as well as the
system components. Check pump oil level daily. The pump
of the pressure washer will require an oil change once a
season or after the first 50 hours of operation and then
every 50 hours after that. Use only 15W40 HD Motor
Oil in the pump. The pump also contains an oil sight glass
and dipstick.
Use a socket wrench to remove the drain plug located on
Drain the oil into a suitable container. Please dispose of
Remove the yellow oil fill plug from pump.
Add oil (15W40 HD Motor Oil) until the oil level is
STEP 1
the side of the pump.
STEP 2
oil properly.
STEP 3
Replace the oil drain plug securely.
STEP 4
STEP 5
halfway up the oil sight glass.
STEP 6
Replace the yellow oil fill plug securely.