Aircommand Cormorant MKII Manuel d'installation et d'utilisation - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Aircommand Cormorant MKII. Aircommand Cormorant MKII 16 pages. Aircommand cormorant mkii rooftop air conditioner
Imprimer la page
- 1. Owners Manual
- 2. Warranty of Refrigerated Airconditioning
- 3. Serial Number
- 4. Main Components
- 5. Before Installation
- 6. Installation Position
- 7. Direction of Travel
- 8. Rear of Unit
- 9. Connect Electrical Supply
- 10. Installation Is Now Complete
- 11. Commissioning of the Unit
- 12. Maintenance
- 13. General Specifications
- 14. Display Setting
4. POSITION CORMORANT ON ROOF
- Remove the air conditioner from the
carton.
- Position the unit over the gasket so that
the corners of the square hole in the
caravan roof line up with the corners of
the
square
hole
underneath
CORMORANT (Fig 6).
TIP: Have one person inside the vehicle
looking through the hole while the other
is on the roof adjusting the position of the
unit
The unit weights approximately
45kg. Ensure a two person lift or
use a mechanical hoist to avoid
the risk of injury.
- DO NOT slide the unit on the roof, this
may damage the gasket and result in
leaks
- Four M8 mounting holes on the chassis
underneath the air conditioner will line
up with the corners of the square roof
hole (Fig 7).
5. ATTACH SPIGOT TO UNIT
- Screw spigot onto underside of unit
with the 4 screws provided
(this step can also be done before the unit
is positioned on the roof but take care not
to damage while fitting)
- The spigot will only fit one way, be
careful to ensure spigot is positioned
correctly (Fig 8) and avoid affixing back to
front
6. CONNECT ELECTRICAL SUPPLY
- This unit MUST be installed in accordance
with State and National Wiring regulations and
in particular AS3001 – 2008
- Connect power supply to lead from unit
- Note:
Brown – Active,
Blue – Neutral
Yellow/Green - Earth
the
Fig 6: Position the CORMORANT over the roof gasket and set it down gently
Fig 7: Shows the view from under the roof
Position the CORMORANT so the 4 mounting holes (circled) line up with the corners
Fig 8: Shows positioning of Spigot to be attached to underside of unit. Ensure spigot is
mounted the correct way, screw holes will not line up if attached back to front
Ensure that power is properly disconnected at the supply (mains and/or
battery). Failure to do so may result in damage to the unit and personal
WARNING
injury or death.