Great Land 1P70F-B Manuel d'instruction et d'utilisation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction et d'utilisation pour {nom_de_la_catégorie} Great Land 1P70F-B. Great Land 1P70F-B 19 pages.

Imprimer la page
Fig. 6
a) Place engine level.
b) Clean around oil fill (1).
c) Remove the fillercap (1).
d) Have a container ready (2) to collect
the oil.
e) Tip the lawnmower on its left side so
that the oil will drain from the oil fill
(3).
f) Place the lawnmower level and top up
with new oil.
g) Check the oil level on the dipstick (4).
Oil should be at «MAX» mark.
h) Close the fillercap and wipe off any
spilled oil.
NOTE
The oil capacity is about 0.6 liter.
Always
dispose
accordance with the legal provisions
on the protection of the environment.
We recommend to bring used oil to
a collection center in a waterproof
container. Never put the oil in the trash
trash. Never pour it on the ground,
never let it seep in.
6.4 CLEAN SILENCER AND
ENGINE
Silencer must be cleaned when the
engine is cold.
a) Remove from the silencer (Fig.1a
–item 5) and its guard (Fig.1a –
item 6) any grass debris or dirt that
could cause fire, using a brush or
compressed air.
b) Clean the cylinder and cylinder head
fins (3) to ease engine cooling and
prevent overheating.
c) Clean the plastic components with
10
a sponge (4) soaked in water and
GB
detergent.
IM moteur 139 cc Outsourced texte-GB.indd 10
of
used
oil
in
6.5 AIR FILTER MAINTENANCE
Fig. 3
a) Clean the area around the filter cover
(1).
b) Remove the cover (1) by releasing
the rear tab (2) and remove the
filtering element (3).
c) Carry out maintenance on the filtering
element as described below for each
type.
d) Clean inside the filter housing to get
rid of any dust and grass cuttings,
taking care not to push them into the
induction pipe.
e) Put the filtering element (3) back in
place and close the cover (1)
CARTRIDGE FILTERING
ELEMENT
Blow compressed air from the inside to
remove dust and grass cuttings.
6.6 SPARK PLUG SERVICE
Fig. 7
a) Remove the spark plug (1) using a
spark plug socket wrench (2).
b) Clean the electrodes (3) with a metal
brush and remove any carbonaceous
build-up.
c) Using a thickness gauge (4), check
for the right gap (0.6 - 0.8 mm)
between the electrodes.
d) Install the spark plug (1) and tighten
with a socket wrench (2).
Replace the spark plug if the electrodes
are burnt or if the porcelain is broken or
damaged.
11/25/2014 2:35:24 PM