Hi-Link HLK-B20 Manuel de l'utilisateur - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Hi-Link HLK-B20. Hi-Link HLK-B20 17 pages. Ble 4.2 wireless module

Imprimer la page

FCC Warning

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

NOTE 1: This product has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This product generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this product does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

Consult the dealer or an experienced radio/TV technician for help.

NOTE 2: Any changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the user's authority to operate the equipment.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. End users must follow the specific operating instructions for satisfying RF exposure

compliance.

Note 1: This module certified that complies with RF exposure requirement under 5mm RF

distance. This transmitter must not be co-located or operating in conjunction with any other

antenna or transmitter.

Note 2: Any modifications made to the module will void the Grant of Certification, this module is

limited to OEM installation only and must not be sold to end-users, end-user has no manual

instructions to remove or install the device, only software or operating procedure shall be placed

in the end-user operating manual of final products.

Note 3: The module may be operated only with the antenna with which it is authorized. Any

antenna that is of the same type and of equal or less directional gain as an antenna that is

authorized with the intentional radiator may be marketed with, and used with, that intentional

radiator.