Great Little Trading Greenaway Gallery Manuel d'installation - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Great Little Trading Greenaway Gallery. Great Little Trading Greenaway Gallery 6 pages. Bookcase
Imprimer la page
Installation Guide
PLEASE READ BEFORE ASSEMBLING THE BOOKCASE:
Decide where you to intend to fit the bookcase. Check the wall for pipes and cables
and ensure that you have a spirit level, pencil, tape measure, drill and drill bits to hand.
Take one of the side panels (either A or B), and place the panel with the outside
face flat against the wall, whilst ensuring the narrow part of the keyhole fixing slot is
uppermost. Ensure that the panel is vertically straight using the spirit level.
B
Mark the position of the centre of the narrow
part of the fixing slots on the wall. Mark the
positions of both upper and lower keyhole
fixing with a pencil.
Remove the side panel from the wall and using
the tape measure and spirit level, measure
784mm horizontally to mark the centres for
the other mounting points.
DO NOT DRILL THE WALL YET
Proceed with the building of the unit.
Installation Guide
AFTER ASSEMBLING THE BOOKCASE:
Start by checking the measurements between all the centres of the keyhole fixings
on the built bookcase are the same as those marked on the wall. If there is a slight
difference, re-measure and adjust the wall markings until you are satisfied that these are
all correct.
Hardware: You must use hardware that is suitable for the wall where the
bookcase is to be mounted. It is not provided.
Ensure you have 4 suitable length countersunk screws/hardware and that the heads of
the screw locate and slide up into the narrow part of the keyhole fixing plates without
pulling out. If they are needed for your wall type, also ensure that you also have the
correct size wall plugs for the screws you are using and that you have the correct sized
drill bit to suit too.
The bookcase can hold up to 20kgs of books, so needs to be firmly fixed to the wall.
If you are unsure, we recommend seeking professional advice before
proceeding further.
Hardware shown here are
for illustrative purposes only.
Your hardware may look
slightly different for your wall.
Drill the holes in the wall and fit the wall plugs (if using). Add the screws and ensure
that the head of the screw is sufficiently proud of the wall to locate into the keyhole
fixing slots.
Carefully offer up the bookcase to the 4 screws and once each is located correctly,
move the unit down to secure to the wall. Each screw head may need to be adjusted
in or out slightly to help with each location point.
ALL 4 KEYHOLE FIXINGS MUST BE USED TO LOCATE THE
4
BOOKCASE.