Gaggenau AW 442 120 CN Manuel d'instruction - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Gaggenau AW 442 120 CN. Gaggenau AW 442 120 CN 12 pages.
Imprimer la page
Operating the appliance
Note: Switch on the extractor hood when you start
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.
Operating the appliance
Control panel
Explanation
#
Fan on/off
1
Fan speed 1
2
Fan speed 2
3
Fan speed 3
Ž
Intensive setting
<
Automatic mode
œ
Saturation indicator
c
Light on/off/dimming
Setting the fan
Note: Always adjust the fan strength to meet current
conditions. If there is a large build-up of steam or fumes,
select a high fan setting.
Switching on
#
1
Press the
button.
The fan starts at setting 2.
2
Press the 1, 2, 3 or
corresponding fan setting.
Switching off
#
Press the
button.
Intensive setting
You can use the intensive setting if there is a large build-
up of odours and fumes/vapours.
Switching on
#
1
Press the
button.
The fan starts at setting 2.
Ž
2
Press the
button.
Intensive mode is activated.
6
Ž
button to set the
Switching off
#
Press the
button or the button for another fan
setting.
Intensive mode is deactivated.
Automatic mode
Switching on
#
1
Press the
button.
The fan starts in fan setting 2.
<
2
Press the
button.
The optimum fan setting 1, 2 or 3 is set
automatically by a sensor.
Switching off
<
#
Press the
or
button.
Automatic mode is switched off.
The fan switches off automatically if the air quality in the
room exceeds a certain level. Automatic mode can run
for a maximum of four hours.
Sensor control
In automatic mode, a sensor in the extractor hood
detects the intensity of the cooking and roasting fumes.
Depending on the setting of the sensor, the fan
automatically switches to another fan speed.
Default sensitivity setting: 2
Lowest sensitivity setting: 1
Highest sensitivity setting: 4
Changing the sensitivity of the sensor
If the sensor control reacts too quickly or too slowly,
change the sensitivity setting.
1
When the fan is switched off, press and hold the
button for approx. 4 seconds.
The setting is displayed.
2
Press button 1, 2, 3 or the
sensitivity setting.
Button 1
= Sensitivity 1
Button 2
= Sensitivity 2
Button 3
= Sensitivity 3
Ž
button = Sensitivity 4
3
Press and hold the
4 seconds.
The change is saved.
Ž
button to change the
<
button for approx.
<