Gaggenau AW 540-720 Manuel d'utilisation et d'assemblage - Page 19
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'assemblage pour {nom_de_la_catégorie} Gaggenau AW 540-720. Gaggenau AW 540-720 20 pages. Gaggenau extractor hood operating and assembly instructions
Imprimer la page
Fig. 24
Fig. 25
18
For circulating air mode use the installation set
included with the ventilation ducts LK 010-112/122
und LK 011-112/122. You also need an activated
charcoal filter (KF 001-010).
Proceed as follows:
– Slightly loosen the screws of the retaining bracket
for the chimney paneling. Hang the angle pieces
onto the screws and tighten the screws.
– Screw the circulating air switch module to the
angle pieces (4 screws).
– Shorten the flexible air pipe accordingly. Fix the
flexible air pipe with hose clamps (Fig. 24).
– Establish the electrical connection.
– Stainless steel chimney only (LK 010-112/122):
pull the protective film off the chimney's trims.
Note: avoid damaging the sensitive metal surfaces.
– Fit the top chimney duct unit into the base. Make
sure that the fastening holes on the side are at the
top.
– Put both chimney duct units onto the hood.
– Pull the top chimney duct unit up into its final
position and secure it with 2 screws on the ceiling
holder (Fig. 25).
Note: avoid scratches when pulling the elements
apart by placing the assembly template, for
example, over the edge of the bottom chimney
paneling to protect it.
– Insert the activated charcoal filters.
– Insert the grease filters.
9000032538
en 06.05 EB