DAYCO D165DC Manuel de l'opérateur - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} DAYCO D165DC. DAYCO D165DC 19 pages.

D165 SERIES HOSE CRIMPING

CRIMPING PROCEDURE

Insert the Standard Pressure Plate in the bottom flange making

certain that the Pressure Plate is seated squarely in the bottom flange.

Make certain that the seating area of the bottom flange is clean and

allows the Pressure Plate to seat squarely in the bottom flange

Select the correct die set for the combination of hose and fitting

being crimped.

The number etched on the die ring represents the fully closed diameter

of the die set in either inches or millimeters depending upon the die

set.

Lubricate the contact surfaces of the die fingers and the

Compression Ring with the die lubricant furnished with the crimper.

Failure to lubricate the contact surfaces with the correct lubricant

can cause the dies to seize in the compression ring.

Align the hose and fitting in the die set. If the fitting has knurl

marks, align as shown. If there are no knurl marks on the fitting,

obtain the correct crimp length from the crimp specification chart and

mark the fitting at the proper point.

CAUTION: The notches on the die set must be

completely covered by the Compression Ring prior

to starting the crimp. If the notches are visible,

you must go to a larger die set. Crimping with

an incorrect die size could result in personal

injury

Page