Dynabrade Electric Dynafile II Sécurité, fonctionnement et entretien

Parcourez en ligne ou téléchargez le pdf Sécurité, fonctionnement et entretien pour {nom_de_la_catégorie} Dynabrade Electric Dynafile II. Dynabrade Electric Dynafile II 8 pages.

Imprimer la page

Buy parts on line at https://Dynashop.co.uk/ for all things Dynabrade

Electric Dynafile

Models:

40590 – 120 V / 60 Hz

40591 – Versatility Kit

(Contains Model 40590, Accessories and Carrying Case)

Read and understand this tool manual before operating your tool. Follow all safety rules for the protection of operating per-

sonnel as well as adjacent areas. For safety information, refer to Code of Federal Regulation – CFR 29 Part 1910, – Safety

Requirements and applicable State and Local Regulations.

Read and understand tool manual before

work starts to reduce risk of injury to

operator, visitors, and tool.

Eye protection must be worn at all times,

eye protection to conform to ANSI Z87.1.

Respiratory protection to be used when exposed to

contaminants that exceed the applicable threshold

limit values required by law.

Some dust created by sanding, grinding, drilling, and other construction activities contain chemicals known to cause cancer, birth

defects or other reproductive harm. Some examples of these chemicals are:

• Lead from lead-based paints

• Crystalline silica from bricks and cement and other masonry products

• Arsenic and chromium from chemically treated lumber

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well

ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.

Caution: Hand, wrist and arm injury may result from repetitive work, motion and overexposure to vibration.

Tool Intent: Dynabrade Electric Dynafile

WARNING! Read and understand all instructions. Failure to follow all instructions listed below, may result in electric shock, fire and /or serious personal injury.

Work Area

1. Keep your work area clean and well lit. Cluttered benches and dark areas invite accidents.

2. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. Power tools create sparks which ignite

the dust or fumes.

3. Keep bystanders, children, and visitors away while operating a power tool. Distractions can cause you to lose control.

Electrical Safety

1. Double Insulated tools are equipped with a polarized plug (one blade is wider than the other.) This plug will fit in polarized outlet only one way. If the plug

does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a polarized outlet. Do not change the plug in

any way. Double Insulation

eliminates the need for the three wire grounded power cord and grounded power supply system.

2. Avoid body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is grounded.

3. Don't expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock.

4. Do not abuse the cord. Never use the cord to carry the tools or pull the plug from an outlet. Keep cord away from heat, oil, sharp edges or moving parts.

Replace damaged cords immediately. Damaged cords increase the risk of electric shock.

Buy parts on line at https://Dynashop.co.uk/ for all things Dynabrade

Tool Manual – Safety, Operation and Maintenance

SAVE THIS DOCUMENT, EDUCATE ALL PERSONNEL

WARNIN G

SAFETY LEGEND

WARNING

II used to sand, debur, blend and polish; metal, wood, stone, fiberglass or plastic surfaces.

GENERAL SAFETY RULES

SAVE THESE INSTRUCTIONS

(continued on next page)

WARNING

Practice safety requirements. Work alert,

have proper attire, and do not operate tools under

the influence of alcohol or drugs.

WARNING

Ear protection to be worn when exposure to sound,

exceeds the limits of applicable Federal, State or

local statues, ordinances and/or regulations.

WARNING

Electric shock hazard. Avoid bodily contact with

grounded objects, bodies of water.

Do not damage cord set.

WARNING

Parts Page Reorder No. PD05•30

Effective July, 2005

Supersedes PD04•17