CEG ECOJET 500PC Manuel d'installation et d'utilisation - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} CEG ECOJET 500PC. CEG ECOJET 500PC 20 pages. Domestic water pump
Imprimer la page
Recommended installation
Valve
Suction lift from bore/well
Recommended installation
Valve
Suction lift from tank below ground
MAINTENANCE
Isolate from the power supply before checking the pump. Any damage to the connecting cable should only be
repaired by a qualified electrician!!
To ensure highest operational safety and reliability at lowest possible cost, the following routine checks are always
recommended at 6 month intervals:
- Check pump and pipe work for leaks
- Check non-return valve and screen (if installed) for debris
- Check pressure tank diaphragm pressure (if installed)
If there is danger of freezing, then it is necessary to completely drain the pump using the drain plug at the bottom of the pump
housing. For prolonged stand-down periods (e.g. winter shutdown) the pump needs thorough cleaning, complete draining
and dry storage. On re-commissioning check for free rotation by briefly switching on the pump on. Then follow installation
procedures set out in this manual.
Any dry-running of the pump must be prevented as it will lead to failure of its internal pump parts!! (ECOJET Electronic
PRESSCONTROL version has built in run-dry protection)!!
10
Every care has been taken to ensure the accuracy of the information contained in this publication, but due to continuous development and improvement the right is reserved to supply products
which may differ slightly from those illustrated and described in this publication.
Drawing 6.0
Non-return valve
Screen
Drawing 6.0
Suction lift from stream
Non-return valve
Screen
Drawing 6.2
Flood suction from tank below ground
Recommended installation
valve
Not recommended installation
Valve
Non-return valve
Screen
Drawing 6.1
Tee w/plug
Non-return valve
Screen
Drawing 6.3