Gaggenau VG425215 Informations pour l'utilisation - Page 13
Parcourez en ligne ou téléchargez le pdf Informations pour l'utilisation pour {nom_de_la_catégorie} Gaggenau VG425215. Gaggenau VG425215 16 pages.
Imprimer la page
Fault
The burner does not
ignite when it is
switched on. The illu-
minated ring behind
the control knob is
flashing yellow and
magenta alternately.
Burner goes out
straight after being ig-
nited.
The burner flame is
not uniform.
The burner flame
goes out while the
appliance is in opera-
tion. The illuminated
ring is flashing or-
ange and white al-
ternately.
The residual heat in-
dicator flashes even
though the appliance
has cooled down.
Burner parts become
darker.
Pan support is discol-
oured.
The appliance does
not heat up. After the
appliance is switched
on, the illuminated
rings on all control
knobs light up white
for 10 seconds, then
the illuminated ring
on the active control
knob lights up or-
ange.
Cause and troubleshooting
Electronics fault.
1.
Turn all of the control knobs to 0.
Disconnect the appliance from the mains power supply for one minute by switching off
2.
the circuit breaker or pulling out the plug.
Connect the appliance again.
1.
a The illuminated rings around the control knobs light up green for a few seconds and then
turn yellow.
Wait until the illuminated rings go out.
2.
Set any of the control knobs to any power level.
3.
4.
Turn the control knob back to 0.
Switch on the burner.
5.
If the illuminated ring starts flashing yellow and magenta again, call customer service
6.
→ Page 15.
Control knob not pressed down long enough.
Keep the control knob pressed down for a few seconds after ignition.
1.
Press the control knob down firmly.
2.
Openings on the burner are soiled.
Clean and dry the openings on the burner.
▶
The burner parts are positioned incorrectly.
Position the burner parts precisely and evenly.
1.
Ensure that the locking catches click into place in the recesses.
2.
Openings on the burner are soiled.
Clean and dry the openings on the burner.
▶
Power failure in the household: Following a power failure, the appliance will remain switched
off for safety reasons.
Turn all of the control knobs to 0.
1.
Switch the appliance back on as required.
2.
The safety shut-off is activated.
Turn all of the control knobs to 0.
1.
Switch the appliance back on as required.
2.
The gas cylinder is empty.
Replace the gas cylinder.
▶
For safety reasons, the residual heat indicator flashes for approximately 30 minutes, even if
the burner was in operation for only a short time.
Do not touch the burner while the residual heat indicator is flashing.
▶
Longer power cut in the household. After the power cut, the residual heat indicator contin-
ues to flash.
Do not touch the burner while the residual heat indicator is flashing.
▶
Natural oxidation of brass
This is normal. This discolouration does not affect their usability.
▶
If cleaned in the dishwasher, the pan support may become discoloured.
This is normal. This discolouration does not affect their usability.
▶
Demo mode is activated.
Deactivate the demo mode. → Page 14
▶
Troubleshooting en
13