Hi-Tech GSM+PSTN Touch Screen Wireless Alarm System Manuel de l'utilisateur - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Hi-Tech GSM+PSTN Touch Screen Wireless Alarm System. Hi-Tech GSM+PSTN Touch Screen Wireless Alarm System 13 pages.

Imprimer la page
Repeatedly receiving the alarm
telephone
Can‟t receive alarm sms or can‟t
receive sms reply after made arm
or disarm operation by sms
The host does not alarm after the
detector is triggered in arm state
The PIR sensor doesn‟t work
The detecting distance of PIR
sensor gets shorter
The host does not alarm after the
new added wireless detector is
triggered.
The PIR sensor flashes frequently
in green.
The door sensor‟s indicator flashes
frequently.
The
distance
of
the
controller gets shorter.
VI. Daily Maintenance and Care
This alarm is the hi-tech product with the outstanding design and sophisticated technique, and shall be used carefully. To make the alarm to
operate for a long term stably and to prolong the service life, it is recommended that:
Try to put the alarm host in the dry and well-ventilated places.
Do not put the host and any wireless detectors in too cold, too hot or dusty places to prevent it from curtailing the service lives of
electric parts and preventing the plastic shell from distorting and accelerating to age.
Do not put the host and any wireless detectors in low and too exposed places to prevent the children from touching them or the
thieves from finding them.
Regular testing is necessary for finding and resolving problems in time.
Regularly check the batteries in all wireless sensors and replace the running out batteries to ensure the normal operation of them.
You‟d better keep the power of the alarm host and all wireless accessories off while a long-time vacancy of the system.
Fail to operate according to the operation
instruction of the telephone alarm
1. SIM card is not insert properly
2. GSM signal is not good enough
1. Caused by the functions of arm mode
(Armed Away and Armed Home);
2. Have already setup time for Entry
Delay or Exit Delay
1. Not properly connected to the power
2. Port of the detector is in the
power-down mode.
The
ambient
temperature
detecting area is too high.
Failed to follow the operation instruction
of "Adding and deleting sensors" to add
the new wireless sensor
Batteries are running out.
Batteries are running out.
remote
Batteries are running out.
Follow the below instructions after answering the alarm
phone calls and hearing the recorded message:
"How to operate the Alarm Host?"
(See Point 6 of
1. Insert SIM card properly
2. Adjust alarm host‟s installation position till the signal
status shows "OK"
1."Armed Away" mode: alarm goes off when any sensor
is triggered;
2. "Armed Home" mode: alarm goes off when any sensor
in Perimeter zone is triggered and it won‟t alarm when
any sensor in Motion zone is triggered
3. Program to adjust the time for Entry Delay or Exit
Delay
1.
Open the sensor shells to install the batteries well
and slide the power switch to "On";
"5S": detect once every 5 seconds;
2.
"5MIN": detect once every 5 minutes;
in
the
When the ambient temperature in the detecting area
exceeds the human body temperature, the detecting
distance will get shorter, it‟s normal.
Follow the operation instruction of "How to program" to
activate the new wireless sensor
Replace with new batteries of the same specification.
Replace with new batteries of the same specification.
Replace with new batteries of the same specification.
)