Hi-Tech 22-229 Manuel d'instruction - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Hi-Tech 22-229. Hi-Tech 22-229 16 pages.

OPERATING INSTRUCTIONS

Carefully unpack the trim saw from the box

and remove all loose foam and accessories.

Set the packaging aside should you need it in the

future. Check to make sure all parts are present

on both the machine and in the instruction

manual. If you find any missing or damaged

parts, call us immediately at 1 (630) 596-9909

Place the trim saw on a table or flat surface that

is in a well lit location. Make sure the machine

sits level.

Carefully remove the black saw table from the

machine. Use both hands and even pressure

to slowly pry the saw table upwards. Note: The

saw table is held in place by four small, tapered

pins. Be careful when removing the saw table,

as the tapered pins may break if not removed

properly.

The removed saw table sits above the water

reservoir. Inside the water reservoir, there

is an aluminum arbor that the saw blade fits

on (Fig. A). Remove the saw knob (Fig. A) that

is screwed into the arbor, turning counter-

clockwise. Place the included, thin notched

diamond saw blade on the end of the arbor,

making sure the 5/8" arbor hole in the saw

blade fits onto the lip. Replace the saw knob

by screwing it back into the arbor, turning

clockwise. The domed washer on the saw knob

secures the saw blade. Do not over tighten, the

saw knob should be slightly tighter than finger

tight. Note: Only use 4" or 5" saw blades with 5/8"

arbor holes on this trim saw machine.

Aluminum arbor

Fig. A

The trim saw is designed to operate with oil

or water. What you use is your preference.

Never run the saw blade dry. Fill the reservoir

with oil or water until the bottom of the saw

blade is 1/8" deep (Fig. B). Do not overfill the

reservoir or there will be excessive oil or water

spraying from the saw blade while you cut.

Saw knob

Fig. B