HI-VAL 3 1/2" 1.44MB Floppy Disk Drive Manuel de l'utilisateur - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} HI-VAL 3 1/2" 1.44MB Floppy Disk Drive. HI-VAL 3 1/2" 1.44MB Floppy Disk Drive 6 pages. 1.44mb

Imprimer la page
Configuring for Drive A: or Drive B:
Use a standard IBM PC compatible floppy ribbon cable with a twist at the end connector (Figure C).
A)
To configure your drive as the A: drive, connect the Floppy Drive to Connector A: on the flat "ribbon" cable
is the end connector of the cable as shown in Figure C.
B)
To configure your drive as the B: drive, connect the Floppy Drive to Connector B: on the flat "ribbon" cable
B:
is the end connector of the cable as shown in Figure C.
C)
Connect the ground cable if your system requires it.
Note: Be sure to make the correct changes to the CMOS BIOS setup after you install your
Notes on Installing your Floppy Drive
Slide the drive into any available 3½" high bay. Make sure the mounting rails are aligned into the marking slots.
Locate your system's floppy drive ribbon cable. The cable may be keyed to assist with alignment. If yours is not keyed, it should
be attached so that the color strip (red or blue) face the center of the drive(jumper block). This is Pin #1.
1.
Re-attach power connector.
2.
Replace the cover to your computer.
3.
Re-attach all input and output devices.
4.
Plug in the computer power cable.
1.44 Floppy Drive
User's Guide
. Connector A:
. Connector
Floppy Drive
Page 3