Dynabrade 95809 Manuel - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Dynabrade 95809. Dynabrade 95809 8 pages. Tune-up kit

Imprimer la page

Important Operating, Maintenance and Safety Instructions

Carefully read all instructions before operating or servicing any Dynabrade

Warning: Hand, wrist and arm injury may result from repetitive work motion and overexposure to vibration.

Important: All Dynabrade air tools must be used with a Filter-Regulator-Lubricator to maintain all warranties.

Operating Instructions:

Warning: Eye, face and body protection must be worn while operating power tools. Failure to do so may result in

serious injury or death. Follow safety procedures posted in workplace.

1. With power source disconnected from tool, securely fasten abrasive/accessory on tool.

2. Connect power source to tool. Be careful not to depress throttle lever in the process.

3. Check tool speed with tachometer. If tool is operating at a higher speed than the RPM marked on the tool or

operating improperly, the tool should be serviced to correct the cause before use.

Maintenance Instructions:

Products offered by Dynabrade should not be converted or otherwise altered from original design without

the expressed written consent from Dynabrade, Inc..

1. Check tool speed regularly with a tachometer. If tool is operating at a higher speed than the RPM marked on the

tool, the tool should be serviced to correct the cause before use.

2. Some silencers on air tools may clog with use. Clean and replace as required.

3. All Dynabrade air motors should be lubricated with two drops of Dynabrade Air Lube (P/N 95842: 1pt. 473ml.)

every four hours of use.

4. An air line filter-regulator-lubricator must be used with this air tool to maintain all warranties. Dynabrade

recommends the following:

11289 Air Line Filter- Regulator-Lubricator — Provides accurate air pressure regulation, two-stage filtration of

water contaminants and micro-mist lubrication of pneumatic components. Operates 28 CFM @ 90 PSI has

3/8" NPT female ports.

5. Gear case of this Dynabrade air tool should be lubricated every 16 hours of use by using 95541 Grease Gun

and 95542 Grease.

Safety Instructions:

• Important: User of tool is responsible for following accepted safety codes such as those published by the American

National Standards Institute (ANSI).

• Operate machine for one minute before application to workpiece to determine if machine is working properly and

safely before work begins.

• Always disconnect power supply before changing abrasive/accessory or making machine adjustments.

• Inspect abrasives/accessory for damage or defects prior to installation on tools.

• Please refer to Dynabrade's Warning/Safety Operating Instructions Tag (Reorder No. 95903) for more complete

safety information.

• Warning: Hand, wrist and arm injury may result from repetitive work, motion and overexposure to vibration.

One Year Warranty

Following the reasonable assumption that any inherent defect which might prevail in a product will become apparent

to the user within one year from the date of purchase, all equipment of our manufacture is warranted against defects

in workmanship and materials under normal use and service. We shall repair or replace at our factory, any

equipment or part thereof which shall, within one year after delivery to the original purchaser, indicate upon our

examination to have been defective.

Our obligation is contingent upon proper use of Dynabrade tools in accordance with factory recommendations,

instructions and safety practices. It shall not apply to equipment which has been subject to misuse, negligence,

accident or tampering in any way so as to affect its normal performance.

Normally wearable parts such as bearings, sanding pads, rotor blades, etc., are not covered under this warranty.

Abrasive Power Tool.