DYNACO PAS-4 Manuel du propriétaire - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} DYNACO PAS-4. DYNACO PAS-4 15 pages. Vacuum tube preamplifier
Également pour DYNACO PAS-4 : Manuel du propriétaire (16 pages)

Imprimer la page

Rear Panel Inputs and Outputs

Inputs - Phono

These inputs will accommodate "moving magnet" or high output "moving coil" cartridges which have

output levels of 1.0mV or higher.

In the lower right hand corner of the rear panel is the preamp's chassis ground terminal. This thumbscrew

is provided for attaching the separate ground wire often provided on turntables. (see Minimizing System

Noise on page 11)

Inputs - Tuner, CD, Video, Aux., Tape 1 & 2

These inputs receive standard line (high level) input signals from other equipment. The Tape Inputs of the

PAS-4 connect to Line Outputs (Play) on tape decks.

Tape Outputs

Signals sent to these outputs are at line level. (Phono signals are first amplified and equalized). Tape

Outputs are unaffected by external processing circuits, the Mono switch, the Volume control, or the

Balance control. The preamp's Tape Outputs connect to the tape deck(s) Line (Record) Inputs .

Preamplifier Main Outputs

Two pairs of outputs are provided for your power amplifier(s). The two left channel RCA jacks are

connected directly together inside of the PAS-4, as is the right channel pair.

EQ (External Processing Loop)

"EQ Out" are line level outputs which can be connected to the inputs of an external signal processor such

as an equalizer, time delay, or noise reduction unit. "EQ In" are for line level inputs coming from the signal

processor outputs.

FUSE

AC Line Fuse:

2 Amp Fast-Blow - 100 or 115 VAC

1 Amp Fast-Blow - 230 VAC

To remove the AC line fuse, use a small screwdriver to push forward the tab near the center of the

Power Entry Module.

Always remove the power cord when accessing the AC line fuse.

PUSH TAB TO RELEASE FUSE HOLDER

120