CEL BL2 Manuel de l'utilisateur - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} CEL BL2. CEL BL2 8 pages. 18v cordless powerblower
Important Notes
1.0
Stay alert Watch what you are doing, use common sense. Do not operate a power tool when you are tired or
distracted.
Before using a tool, check that there are no damaged parts. If a part is slightly damaged, carefully determine it will
operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts,
breakage of parts, proper mounting and any other conditions that may affect the operation of the tool. A guard or other
part that is damaged should be properly repaired or replaced by an authorized service facility, unless otherwise indicated in
this Instruction Manual.
Defective switches must be replaced by an authorised service facility. Do not use a tool if the switch does not turn the
tool on and off correctly.
Guard against electric shock. Prevent contact with grounded objects such as water pipes.
Use only approved parts. When servicing, use only identical replacement parts. Use an authorised service facility to fit
replacement parts.
Do not let tool run unattended. Always wait until your power tool has come to a complete stop and remove the battery
before leaving it.
Damaged batteries must be disposed of immediately. Liquids contained within can be extremely harmful.
WARNING. The use of an accessory or attachment, other than those recommended in this Instruction Manual, may
present a risk of personal injury.
The tool must be used only for its prescribed purpose. Any use other than those mentioned in this Manual will be
considered a case of misuse. The user and not the manufacturer shall be liable for any damage or injury resulting from
such cases of misuse.
Additional safety rules for blowers
Never point the blower in the general direction of any person, animal or delicate object as debris may be flung by the air stream.
Do not use the blower in the rain or in a damp area.
Keep hands and fingers well away from the outlets, air stream and moving parts.
Wear work gloves, eye, ear and breathing protection, solid shoes and suitable clothing while using this blower.
Always grasp both handles when operating the unit, only operate the machine in its intended orientation.
Remove the battery when you have finished blowing, before cleaning or if you have been interrupted.
This blower has been designed to clear light debris and leaves from hard surfaces not for clearing grassed areas.
Do not attempt to free debris or adjust the blower and it's accessories before first switching off the machine and removing the
battery.
Check the area to be cleared for stones and anything that may be flung by the tool. Remove wire and string as it may damage the
blower.
Do not block the air outlets, this may damage the tool and cause injury.
Never use the machine without the safety devices properly fitted and undamaged
WARNING, the guards are for the safety of the operator and bystanders, never remove them while operating the machine.
Never touch or go near the blowing area while the motor is still turning, the tool may take a few seconds to slow down after the
trigger is released.
Only use battery as supplied or identical replacements designed specifically for this tool.
Only blow if lighting levels are adequate.
Do not activate the tool if there is debris in the vents or otherwise obstructing operation.
Release trigger when moving between work areas, gravel paths can create flying debris danger.
If the machine appears to have any fault or makes any unusual sounds please consult the manual a service centre or your retailer.
If you are interrupted while operating the trimmer, complete the process and switch off before looking up.
Never allow untrained users or children to use the blower.
Wear goggles, Wear ear protections, Wear breathing protection,
Wear work boots, Wear protective clothing.