HiB Novum Duet Instructions de montage - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} HiB Novum Duet. HiB Novum Duet 4 pages.

Imprimer la page
Duet Vanity Units
1. Position the unit in a suitable location. Carefully mark the desired position of the unit using a soft
pencil.
2. Using a spirit level, mark a horizontal line below the pencil mark, taking into account the location
of the furniture hangers. Bend and break the wall brackets as shown in
on the pencil line paying attention to the distance between the inner sides of the unit. Carefully
mark the position of the holes using a soft pencil.
3. Before drilling, ensure there are no hidden cables or pipes behind the mounting
points. Using a suitable drill bit, drill holes in the marked positions to a suitable depth.
4. Insert wall plugs level with the surface of the wall. If fitting to a tiled surface, wall plugs should be
inserted below the tile surface to avoid cracking. NB. For plasterboard walls, specialist heavy
duty fixings should be purchased from any DIY or hardware store.
5. Fix the brackets to the wall using the screws provided
6. Hang the furniture unit, ensuring the claws on the hangers are securely located on the wall
brackets. Using a spirit level, make the unit level by adjusting screw B on the hangers
Once straight, tighten screw A until the unit is secure against the wall.
7. Remove the bottom drawer from the carcass by removing the securing screw on the underside of
the drawer runner
8. Using a spirit level, ensure that the side of the carcass is completely vertical, so that the unit is
sitting completely square. Now mark the drill locations in the centre of the metal brackets at the
bottom of the carcass
9. Using a suitable drill bit, drill holes in the marked positions to a suitable depth. Insert wall plugs
level with the surface of the wall. If fitting to a tiled surface, wall plugs should be inserted below
the tile surface to avoid cracking. NB. For plasterboard walls, specialist heavy duty fixings
should be purchased from any DIY or hardware store.
10. Rehang ensuring unit is once again level.
11. Using the screws provided, fix the bottom brackets to the wall to secure the base of the carcass in
place
(Fig
4).
12. Reinsert the drawer into the unit and secure in place with the screws removed previously. If
necessary, the drawer runners can be adjusted in order to align the drawer front(s), this is done by
turning the small adjuster wheel before tightening the securing screws
13. Lastly, mount the basin onto the furniture unit using a fine bead of silicone to seal the washbasin to
the unit and wall edges.
2
(Fig.
7).
(Fig.
4). Now remove the carcass from the wall.
Fig. 1
(Fig.
2).
(Fig.
2).
(Fig.
and place brackets
(Fig.
3).
5).