HiB Qubic 80 Manuel - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} HiB Qubic 80. HiB Qubic 80 4 pages.
Imprimer la page
Fixing Preparation (Fig A)
Fixing Brackets (Fig B)
Wall Hung Installation
Ensure the domestic electrical mains supply to
which the cabinet is being connected is turned
off.
1. Position the cabinet in a suitable location
(according to the zonal diagram (Fig 1) on
the back page) ensuring that the mains
supply cable is within reach of the cable
connection point of the cabinet. Carefully
mark the desired position of the cabinet
using a soft pencil, ensuring it is level.
2. Remove the cabinet from the wall and using
a spirit level, mark a horizontal line below
the pencil mark, taking into account the
location of the mounting points (Fig. A).
Place brackets on the line paying attention
to the distance between the hangers on the
cabinet. Carefully mark the position of the
holes using a soft pencil. (Fig. B).
3. Before drilling, ensure there are no hidden
cables or pipes behind the mounting point.
Using a suitable drill bit, drill holes in the
marked positions to a suitable depth.
4. Insert wall plugs level with the surface of the
wall. If fitting to a tiled surface, wall plugs
should be inserted below the tile surface
2
REAR VIEW
Mounting Points
Location of internal
xing hole (SINGLE DOOR)
Location of internal
xing hole (DOUBLE DOOR)
Hanger Adjustment (Fig C)
to avoid cracking. NB. For plasterboard walls,
specialist fixings should be purchased from any
DIY or hardware store.
5. Fix the brackets to the wall using the screws
provided.
6. Carefully remove the small screws along the
top front edge of the cabinet to gain access
to the internal panel(s). (Fig. C) Keep screws
in a safe place.
7. Temporarily hang the cabinet ensuring the
claws on the hangers are securely located on
the wall brackets. Using a spirit level adjust
the cabinet via the screws on the hangers.
(Fig. C).
8. Mark the position of the internal fixing
hole(s) and remove the cabinet. Using a
suitable drill bit, drill the holes and insert the
wall plugs as per stage 4 above.
9. Connect the cable at the rear of the cabinet
to the mains supply cable using a suitable
terminal block (not supplied) according to
the wiring diagram (Fig. 2) on the back page.
10. Rehang the cabinet in position, tighten the
screws on the hangers (Fig. C) and secure the
base of the cabinet with the supplied screws
and screw caps.
Angle Adjustment
Claw In/Out
Claw In/Out
Adjustment
Adjustment