GREAT PLANES avistar elite Manuel d'instruction - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} GREAT PLANES avistar elite. GREAT PLANES avistar elite 20 pages.

Imprimer la page

GREAT PLANES avistar elite Manuel d'instruction

❏

3. Slide the wing panels together onto the joiner tube.

❏

4. Connect the aileron (and ﬂ aps if applicable) servo leads

to the Y-harness.

❏

5. Fit the plywood wing root tabs into the slot in the fuselage.

❏

6. Use the included 1/4-20 nylon wing bolts to secure the

wing in place. The tool shown in the picture is a Great Planes

4-In-1 Installation Tool (GPMR8035 not included).

❏

7. You are now completed with the assembly of your Avistar

Elite. Continue with the ﬁ nal setup of your model.

Apply the Decals

❏

1. Use scissors or a sharp hobby knife to cut the decals

from the sheet.

❏

2. Be certain the model is clean and free from oily ﬁ ngerprints

and dust. Prepare a dishpan or small bucket with a mixture

of liquid dish soap and warm water—about one teaspoon of

soap per gallon of water. Submerse the decal in the soap and

water and peel off the paper backing. Note: Even though the

decals have a "sticky-back" and are not the water transfer type,

submersing them in soap & water allows accurate positioning

and reduces air bubbles underneath.

❏

3. Position decal on the model where desired. Holding the

decal down, use a paper towel to wipe most of the water away.

❏

4. Use a piece of soft balsa or something similar to squeegee

remaining water from under the decal. Apply the rest of the

decals the same way.