GREAT PLANES Big Stir 40 Manuel d'instruction - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} GREAT PLANES Big Stir 40. GREAT PLANES Big Stir 40 20 pages.

❏

6. Place the wing on the fuselage. Measure from the aft

center of the fuselage to one wing tip and record the

distance. Measure from the same point to the opposite wing

tip and compare it to the first measurement. If the

measurements are not the same, adjust the wing and re-

measure until they are equal. Place a mark on the wing and

the fuselage so it can be repositioned accurately for the

following steps.

❏

7. Make two additional reference marks on the fuselage,

aligning them with the center of the wing bolt blocks in

the fuselage.

❏

8. With a 1/8" (3mm) drill bit, drill two pilot holes through

the wing and the wing bolt block. Use the reference marks

you made on the fuselage as a guide and the center the drill

on the wing plate.

❏

9. Remove the wing. Use a #8 (5.2mm) or 13/64" drill bit

and drill through the pilot holes in the wing bolt blocks. Use

a 1/4 - 20 tap to thread the wing bolt blocks. After you have

the blocks tapped, wick some thin CA into the threads. After

the glue has dried, run the tap through the blocks once more

to clean out any excess glue.

❏

10. Drill a 1/4" (6mm) hole through each of the pilot holes

in the wing. This will provide clearance for the wing bolts to

pass through the wing.

INSTALL THE TAIL COMPONENTS

❏

1. Cut 5 hinge slots in the horizontal stabilizer and the

elevator the same way you did for the ailerons. Test fit the

elevator to the horizontal stabilizer but do not glue them in

place yet.

❏

2. Cut 3 hinge slots in the fin and the rudder the same

way you did for the ailerons. Test fit the fin to the elevator but

do not glue them in place yet.