GREAT PLANES Dazzler ARF Manuel d'instruction - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} GREAT PLANES Dazzler ARF. GREAT PLANES Dazzler ARF 20 pages.

28. Cut unused arms from a leftover servo arm.

29. Drill a 1/16" [1.5mm] hole in bottom of the radio

compartment cover.

30. Use the arms to make a strain relief for the antenna

wire. After cutting the servo arms, thread the antenna

through the hole you drilled in the radio compartment cover

and attach the antenna to the vertical fin with a rubber band

and T-pin as shown above.

31. Turn on the receiver and radio to center the servos

for the ailerons. Install a servo arm onto the servo so that the

arm is parallel to the aileron.

32. Install a control horn onto the left aileron using the

same installation technique used for the elevator and rudder.

a silicone clevis keeper onto the wire then attach a clevis by

turning it onto the threaded end of the pushrod 14 turns.

Cut Off

Unused

Arms

pushrod where it lines up with the outermost hole in the

servo arm. Make a 90-degree bend at the mark. Cut the rod

above the bend to a length of 3/16" [4.8mm].

was done for the elevator and rudder.

the radio compartment cover in place on the wing.

drilling through the cover and the hardwood blocks you

glued in place earlier.

each of the holes you drilled.

compartment cover and the fuselage. Drill a hole in the

fuselage where each strap contacts the fuselage. Then

screw each strap to the fuselage.

33. Locate one of the 6" [150mm] wire pushrods. Install

34. Center the aileron. Make a mark on the solid wire

35. Attach the pushrod to the aileron the same way it

36 Repeat this procedure for the right aileron.

INSTALLING THE RADIO

COMPARTMENT COVER

1. Turn the airplane upside down on your bench. Trial fit

2. Drill a 1/16" [1.6mm] hole in the corners of the cover,

3. Attach a nylon strap with a #2 x 1/2" [13mm] screw at

4. Position the straps so that they lay across the radio