GREAT PLANES Dazzler ARF Manuel d'instruction - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} GREAT PLANES Dazzler ARF. GREAT PLANES Dazzler ARF 20 pages.

INSTALL THE FIN AND RUDDER

1. If you haven't already cut away the covering in the slot

where the fin and rudder assembly are installed, do so now.

2. Slide the fin into the slot. Make a mark on the end of

the fuselage where the hinge from the rudder needs to slide

into the fuselage.

3. The pre-cut slot in the fuselage for the rudder hinge

may be a bit tight for the hinge. With a #11 knife blade, widen

the slot until the hinge fits the slot with enough room to be

able to get epoxy in the slot with the hinge. Test fit the fin

onto the fuselage, making sure the hinge fits into the slot.

4. Use a felt tip-pen to mark the sides of the fin where it

meets the fuselage.

5. Cut the covering away from the fin inside the lines you

just made, being careful not to cut into the wood. Remove

any film that may be on the bottom of the fin where the

bottom of the fin makes contact with the fuselage.

6. Apply a small amount of petroleum jelly or small drop

of oil onto the joint of the hinge. This will prevent the glue

from getting into the hinge when gluing it to the fuselage.

7. Apply a liberal amount of 30-minute epoxy to the fin

and the hinge. Put the fin assembly in place on the fuselage.

8. Use a triangle to make certain that the fin is exactly 90°

to the stab. Use masking tape to hold the fin in position to

the stab while the glue cures.

1. Determine the position for the throttle linkage that best

suits the engine you are installing. We used the O.S. 40 LA.

Determine which hole in the corner of the firewall best fits

your engine, then insert the plastic outer pushrod to pass

through it.

2. Install the outer plastic pushrod through the fuel tank

compartment and under the wing. Do not glue the pushrod

in place yet!

90˚