ActiveAid 1100 Manuel du propriétaire - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} ActiveAid 1100. ActiveAid 1100 20 pages.

Usage

Seat

Remove by lifting one corner at a time or lift off one side only and pivot the seat up from the opposite side.

Install the seat by aligning opposite corners and snapping into place on the frame. Make sure that the seat is

square, and all 4 corners are snapped into place before sitting on chair.

Back

Loosen then remove the self-locking nut and screw that are securing the back assembly to the frame. Pull up on

the back assembly. Re-insert the screw through the holes in the chair frame. Hand start the nut onto the end of

the screw.

Adjustable Depth Back

Loosen knobs, slide back pad to desired position, tighten knobs.

Adjustable Sling Back

Loosen strap to decrease tension, tighten strap to increase tension.

Leg Rests

Adjust the height of the foot plate by depressing snap button and sliding foot plate mount up or down to obtain

correct height. Remove leg rest assembly by lifting up on the gooseneck to remove it from the receiver of the

front support.

Elevating Leg Rest

Adjust the height of the leg rest by depressing snap button and sliding foot plate mount up or down to obtain

correct height. Adjust the angle of the leg rest upward by lifting, lower by depressing the tab.

Arm Rests

Height-Adjustable Arm Rests

To raise the arm, push up on the armlock cap and pivot back the entire armrest. To lower the arm, pull down on

the front of the armrest until the arm latch locks onto the securing stud under the arm pivot.

Flip-Up Arm Rests

To raise the arm up, pivot the arm lock lever away from the armrest and armrest lock. Lift up on the armrest.

Remove by depressing the snap button and sliding it out of the armrest pivot.

Casters

Locking casters: To lock casters (option), push down on the front of the caster brake lever. To release caster

brake, push down on the rear of the caster brake.

Removing Casters: Loosen then remove the self-locking nut and machine screw that are in the chair frame

where the casters will be inserted. Insert caster so that it is flush with the frame. Re-insert the screw through

the holes in the chair frame and caster stem. Note: Screw head should be to the outside of the frame and the nut

to the inside. Hand start the nut onto the end of the screw Use a wrench and hex key to tighten the casters into

place. Repeat for second caster.

Wheels

Quick Release Axle

Depress button on the axle end to recess the ball locking pins and start the bolt thru the wheel. Place washer on

bolt end to inside of wheel. Continue depressing the button to insert the bolt into the wheel mount.

Note: The ball locking pins will secure the axle in place when the button is released.

Wheel Locks

To engage the wheel lock, push forward on the lever, to unlock pull back on the lever.

Note: If the wheel moves while wheel lock is engaged, the assembly needs to be moved slightly closer to

the wheel.