GREAT PLANES Micro Whizz Manuel d'instruction - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} GREAT PLANES Micro Whizz. GREAT PLANES Micro Whizz 16 pages.

Imprimer la page

GREAT PLANES Micro Whizz Manuel d'instruction

Installing the Receiver

& Speed Control

1. The areas where you will be mounting your receiver,

speed control, and battery must have a thin coating of glue

to allow the Velcro to attach. You can use CA or any type of

wood glue for this purpose. Allow the glue to dry or cure

completely before attaching the Velcro. Note the location of

the mounted speed control in the above photograph.

2. The photograph illustrates the placement of the

receiver. Place a 1/16" [1.6mm] hole close to the receiver in

the bottom of the fuselage. Feed the antenna through this

hole and tape it into place on the wing.

3. Note the installation and position of the battery pack.

4. Install the hatch.

Apply the Decals

1. Use scissors or a sharp hobby knife to cut the decals from

the sheet.

2. Be certain the model is clean and free from oily

fingerprints and dust. Prepare a dishpan or small bucket

with a mixture of liquid dish soap and warm water–about

one teaspoon of soap per gallon of water. Submerse the

decal in the soap and water and peel off the paper backing

while the decal is in the soapy water. Note: Even though the

decals have a "sticky-back" and are not the water transfer

type, submersing them in soap & water allows accurate

positioning and reduces air bubbles underneath.

3. Position decal on the model where desired. Hold the

decal down and use a paper towel to wipe most of the

water away.

4. Use a piece of soft balsa or something similar to

squeegee remaining water from under the decal. Apply the

rest of the decals the same way.

GET THE MODEL READY TO FLY

Check the Control Directions

Note: For safety reasons, remove the propeller from the

airplane before proceeding.

1. Turn on the transmitter and receiver and center the

trims. If necessary, remove the servo arms from the servos

and reposition them so they are centered. Reinstall the

screws that hold on the servo arms.

2. While the transmitter and receiver are still on, check all the

control surfaces to see if they are centered. If necessary, adjust

the clevises on the pushrods to center the control surfaces.

TRANSMITTER

3. Make certain that the control surfaces respond in the

correct direction as shown in the diagram. If any of the

controls respond in the wrong direction, use the servo

4-CHANNEL