GREAT PLANES Micro Whizz Manuel d'instruction - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} GREAT PLANES Micro Whizz. GREAT PLANES Micro Whizz 16 pages.

7. With the horizontal stabilizer placed bottom up on a flat

surface, place the tail boom (with the bracket attached) on

top of the stabilizer as shown in the above photographs with

the rear of the assembled tail boom positioned on the

centerline and the 3/16" [5mm] mark. Make the correct

alignment by measuring the distance from the tip of the tail

boom to both forward corners of the horizontal stab. Make

the necessary adjustments until both measurements are

equal on both sides.

8. When you are satisfied with the correct position of the tail

boom, mark the position of the bracket onto the stabilizer.

9. Using a sharp hobby knife cut away the covering just

inside the lines you drew on the covering. Do not cut into the

balsa as this will weaken the structure. Glue the tail boom

into place with CA. While the glue cures check the

positioning with a ruler in the same way as when you

marked the location.

10. Cut a slot into the right elevator at a point 3/16"

[5mm] toward the outer end of the elevator from the inside

edge of the elevator. Place the control horn into the slot in a

manner that allows the holes in the horn to align with the

hinge line as shown in the above photograph. Make sure

that the horn is placed on top of the elevator. When you are

satisfied with the placement, glue it into place with CA.

11. Place the fin/rudder into the slot on top of the horizontal

stabilizer. Use a felt-tipped pen and mark the position on both

the fin and the stabilizer as shown in the photograph above.

12. Using the same procedure as before, cut the covering

away from the top of the stabilizer as shown in the

photograph above. Do the same with the base of the fin

where you made the marks. Before gluing the fin/rudder into

place in the next step, position the control horn for the

rudder into the left side of the rudder and glue the control

horn into place with CA.