GREAT PLANES Spectra Manuel d'instruction - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} GREAT PLANES Spectra. GREAT PLANES Spectra 16 pages.

connect it to the servo arm at the last hole. Follow the same

procedure for the elevator. Make sure all the FasLinks are

securely attached. Cut the excess pushrod 1/16" [1.6mm]

from the FasLink.

Canopy Installation

1. Place a piece of wax paper between the fuselage and

the bottom canopy base. Situate the front canopy brace

and rear canopy brace in place. Press all braces against

the fuselage to obtain their correct position. Glue the front

and the rear braces to the base with medium CA. The wax

paper will prevent the braces from accidentally being glued

to the fuselage. Note: You may have to sand the braces

slightly to get them to fit. For the instruction model we used

Great Planes Plan Protector

2. Make a 9/64" [3.6mm] hole in the front canopy brace

and fuselage as shown. Insert the small hardwood dowel

into the hole until it extends all the way into the fuselage

hole. Glue in place with thick CA. Be careful not to glue the

dowel to the fuselage.

3. Test fit the canopy onto the canopy braces. Use Pacer

Formula 560 to glue the canopy to the canopy braces.

™

(GPMR6167).

4. Trim the canopy flush with the base and the front of the

canopy braces but do not trim the back yet!

5. Temporarily mount the wing in place on the fuselage.

Very carefully trim the back of the canopy, A LITTLE AT A

TIME, to fit over the wing. Curved tip scissors work well for

trimming the canopy.

6. Open the air intake on top of the canopy.