GREAT PLANES Spirit Manuel d'instruction - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} GREAT PLANES Spirit. GREAT PLANES Spirit 16 pages. 2-meter sailpane
Imprimer la page
❏ ❏
D. Add six drops of thin CA to the center of the hinges
on both sides. Use a paper towel to absorb excess CA from
the hinge gap before it cures. Do not use CA accelerator;
allow the CA to cure slowly.
❏
5. Use the same hinging method to join the elevators to
the stab.
❏
6. Position one of the nylon control horns up 1/2"
[13mm] up from the bottom of the rudder. Align the horn
parallel to the bottom of the rudder. Drill two 3/32" [2.5mm]
holes through the rudder using the horn as a guide. Harden
the holes using two or three drops of thin CA. Attach the nylon
control horn to the rudder using two 2mm x 15mm screws.
❏
7. Position the remaining control horn in line with the center
of the fuselage on the bottom of the elevator. Attach the
control horn to the elevator using two 2mm x 15mm screws.
RADIO INSTALLATION
❏
1. Slide one hardwood 3/8" x 1/4" x 2" [9.5mm x 6mm x
50mm] servo rail into its slot in the fuselage doubler. Slide
it all the way forward and glue it in place with thick CA. Slide
the other servo rail into place and then slide it all the way aft.
Do not glue it yet! Position one of your servos in place and
use it to position the rear servo rail. Do not push the rear
servo rail tight against the servo, but rather leave about a
3/32" [2.5mm] gap between the servo "body" and the aft
servo rail. This will provide enough room to install and
remove the servos without removing the rails. Glue the rear
servo rail in place.
7