GREAT PLANES Sport Float Kit ARF Manuel d'instruction - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} GREAT PLANES Sport Float Kit ARF. GREAT PLANES Sport Float Kit ARF 16 pages.
Imprimer la page
ASSEMBLY
Install the Steering Servo
1. Use the servo tray to mark the outline of the tray on
one of the floats with a fine-tipped marking pen as shown in
the photo above. The tray should be located 1/2" [13mm] aft
of the rear groove in the float. This float is now the right float.
2. Very carefully cut the marked area from the float with
a razor saw. The piece you cut out will be used as the tray
cover, so use care not to damage it. Mark the end of the
cover that was facing forward.
3. Glue the servo tray to the inside of the cover with
epoxy. Use some medium grit sandpaper to rough up the
inside of the cover first. Mark the tray indicating which end
of the cover faces forward.
Note: The tray may not have the cutout shown in the
above photo.
4. Clean any resin residue from the tray opening in the
float. Trim any resin from the hardwood mounting rail inside
the float. Put one of the 1/4" x 3/8" x 3-1/2" [6.4 x 9.5 x
89mm] basswood servo tray rails in the float, butting one
end against the mounting rail. Mark the rear of the opening
on the rail. Transfer the mark to the other rail as well.
5. Glue a 1/8" x 3/8" x 1/2" [3.2 x 9.5 x 12.7mm] ply rail
spacer to each of the servo tray rails as shown in the photo.
In the photo, the mark is to the left of the spacers.
6. Using medium CA, tack glue the servo tray rails into
the float opening with the spacers toward the rear of the
float. Scuff the area with some medium grit sandpaper to
improve the adhesion.
7. Trial fit the servo tray to the top of the rails. If the tray
sticks up above the top of the float, remove the servo tray
5