Automate AM2 Manuel d'installation - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Automate AM2. Automate AM2 18 pages.
Également pour Automate AM2 : Manuel du propriétaire (19 pages)
Imprimer la page
2.
3.
4.
Channel Number
1
2
3
4
5
6
7
8
**NOTE: For Auto Learn Configurations, see Transmitter Configurations section of this guide.
C C h h a a n n n n e e l l # # 8 8 : : If any button from a known transmitter is programmed to Channel 8, all transmitters
will be erased from memory and the system features will revert to the default settings. This is useful
in cases where the one of the customer's transmitters is lost or stolen. This will erase any lost or
stolen transmitters from the system's memory. It can also be used to start from scratch if the trans-
mitter buttons or features were programmed incorrectly.
To exit the learn routine:
One long horn honk indicates that Learn Routine has been exited.
➤ ➤
Ignition is turned off.
Valet/Program button is pressed too many times.
➤
➤ ➤
More than 15 seconds elapse between steps.
14
.
C C h h o o o o s s e e . . Within 10 seconds, press and release the Valet/program switch
the number of times corresponding to the desired channel listed below.
Once you have selected the channel, press the switch once more and
HOLD it. The LED will flash and the horn will honk ( if connected) to
confirm the selected channel. Do not release the Valet/program switch.
T T r r a a n n s s m m i i t t . . While holding the Valet/Program button, press the button
from the transmitter that you wish to assign to the selected channel. The
unit will chirp indicating successful programming. It is not possible to
teach a transmitter button to the system more than once.
R R e e l l e e a a s s e e . . Once the code is learned, the Valet/Program button can be
released.
Function
Auto Learn
Lock/Arm only
Unlock/Disarm only
Channel 2
Channel 3
Arm/Disarm/Panic
Panic Only
Delete all transmitters
Wire Color
RED/WHITE
WHITE/BLUE
©
2007
Directed Electronics