Automate AM2 Manuel d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Automate AM2. Automate AM2 18 pages.
Également pour Automate AM2 : Manuel du propriétaire (19 pages)

Imprimer la page

H1/14 WHITE/BLUE (-) Channel 3 Output

This wire provides a (-) 200 mA output whenever the transmitter code controlling Channel 3 is

received. This output will continue as long as that transmission is received. Use for options such as

Directed's 561T Valet

Start system, 529T or 530T power window controllers, etc.

IMPORTANT! Never use this wire to drive anything but a relay or a low-current input!

The transistorized output can only provide (-) 200 mA of current, and connecting

directly to a solenoid, motor, or other high-current device will cause it to fail.

H1/15 YELLOW (+) Switched Ignition Input

Connect this wire to an ignition source. This input must show (+)12V with the key in run position

and during cranking. Make sure that this wire cannot be shorted to the chassis at any point. This

wire will trigger the system if the ignition is turned on before the unit is disarmed (doors unlocked

with the remote). It will also honk the vehicle's horn and flash the parking lights (if connected).

2007

Directed Electronics