Emerald Planet EP-RF-R1 Manuel de l'utilisateur - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Emerald Planet EP-RF-R1. Emerald Planet EP-RF-R1 6 pages.

Imprimer la page

INSTALLATION POSITIONING ADVICE

When mounting an alarm on the ceiling, locate it a minimum of 30 cm from the side wall (see Diagram 5).

• Put smoke alarms at both ends of a bedroom hallway or large room if larger than 10m long.

• Install smoke alarms on slopped, peaked or cathedral ceilings between 500 and 1500mm from the highest point of the ceiling.

Smoke alarms in rooms with ceiling slopes greater than 1m in 8 m horizontally should be located on

the high side of the room (See Diagram 6)

DIAGRAM 4

MULTIPLE FLOOR PLAN

WIRELESS PAIRING

WIRELESS FREQUENCY:

OPERATION CURRENT:

MAXIMUM NUMBER OF

INTERCONNECT PRODUCTS

WIRELESS DISTANCE

EMERALD PLANET HEAD OFFICE - SYDNEY Unit 2 / 29 Mitchell Road, Brookvale NSW 2100 Australia P 02 9466 6000

DIAGRAM 5

CEILING PLACEMENT

433MHz

RF Receiver: <5mA

RF emitter: <10mA

30PCS

> 20 meters

Note: Make sure the batteries are

installed correctly before

operating the product.

DIAGRAM 6

PEAK CEILING PLACEMENT

SLOPED CEILING PLACEMENT

Smoke alarm should be located

between 500mm and 1500mm

from the highest point.

To pair with additional Emerald Planet RF

Smoke Alarms

Before installing the smoke alarms in their locations, it is

necessary to "pair" them to each other. Ensure all alarms

are ready to pair and powered correctly with batteries.

Press and hold the test button on one alarm until the

red LED light illuminates and stays lit. (Please note: The

alarm will sound during this time), release the button.

The alarm is now in "Wireless Pairing Mode".

While the first alarm is in Wireless Pairing Mode", Press the

test button of the alarm that you wish to pair with it for 1

second then release. The red LEDs will flash rapidly for 2

seconds on both alarms indicating successful pairing.

If there is no alarm response to this command within 30

seconds, pairing was unsuccessful and the unit will exit

"Wireless Pairing Mode" automatically. Return to point a and

try again.

To Cancel Pairing

Press and hold the test button on the alarm until the red

LED flashes for about 1 second (approx. 16 seconds) and

release the button.

After releasing the button, press the button when the red

LED lights up, release the button when the red LED is off,

if you hear the sound of two beeps in quick succession

repeating, that indicates that Pairing is cancelled.