HiB Stratus 50 Instructions de montage - Page 3

Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} HiB Stratus 50. HiB Stratus 50 4 pages. Led illuminated steam free cabinets

Imprimer la page
and remove the cabinet. Using a suitable
drill bit, drill a hole and insert a wall plug as
per stage 4.
9. Connect the cable at the rear of the cabinet
to the mains supply cable using a suitable
terminal block (not supplied) according
to the wiring diagram (Fig. 2) on the back
page.
10. Rehang the cabinet in position, tighten the
screws on the hangers (Fig. C) and secure
the base of the cabinet with the supplied
screw and screw cap.
11. Once fully secure, close the internal panel(s)
using the screws removed at stage 6.
12. Fit shelves in desired positions using metal
shelf supports.
13. Reattach the door(s) ensuring the hinges
fully locate and click back into position.
14. If necessary, the hinges can be adjusted in
order to reposition the door(s) (Fig.D).
15. Switch the mains supply back on.
Move door(s) up/down
Move door away/towards
the cabinet
Move door(s) left/right
Door Adjustment (Fig D)
Operating Instructions
To turn illumination on or off, wave your hand
under the sensor switch located at the bottom
of the cabinet. Charger socket is suitable
for charging and powering electric razors,
trimmers and toothbrushes.
NB. On first use of the charger socket,
inserting the shaver plug may prove to be stiff.
Reasonable force may be required to fully insert
the plug. Make sure that the cabinet is held
firmly so that it is not pushed off the wall. After a
few uses, stiffness will ease and the socket will
function as normal.
How to isolate the sensor so you can
switch ON & OFF with a mains switch.
How the cabinet is wired.
live
earth
neutral
Shaver socket/transformer
Sensor switch controller
LED driver
How to isolate the sensor.
live
earth
neutral
Shaver socket/transformer
Sensor switch controller
LED driver
Rewire the cabinet as shown in the diagram
above. HiB recommends that all electrical
bathroom products should only be fitted by a
suitably qualified, Part P registered electrician.
For further assistance on isolating the sensor
please contact us.
Tel:
020 8441 0352
Email:
hib.co.uk
3