Celebrations Home 9016668 Manuel de démarrage rapide - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Celebrations Home 9016668. Celebrations Home 9016668 3 pages. 12 ft illuminated grand fir tree

Imprimer la page

Assembly / Operation Instructions / Troubleshooting

ASSEMBLING THE TREE STAND

Step 1. Choose a location near a wall outlet.

Step 2. Unfold the legs of the tree stand (G) and lay the stand on the floor.

Step 3. Slide the locking disk of the tree stand (G) down until it snaps into place.

ASSEMBLING THE TREE

Step 1. Remove the protective caps from the tree bottom and insert the pole into

the tree stand.

Step 2. Continue by inserting the upper tree section(s) to the lower section(s)

until inserting the tree top.

Step 3. Shape the branches to your preference by working from the bottom to

the top. When adjusting branches, ensure that all wires are free of

branch hinges.

Step 4. Insert the green label adapter plug into the wall outlet. All your lights

should now be lit.

Step 5. Shape the tree from the bottom to the top. Start with the branches

farthest from the pole – fan out in a star shape, and continue until

the entire tree is shaped.

Top view

Step 6. This is a Simple Shape

tree and no shaping is required. Just slightly

upsweep and shift branches to fill in any gaps for a fuller, uniform look.

Your Christmas tree is now ready to be decorated.

TROUBLESHOOTING TIPS

FOR PRE-LIT TREES, IF THE TREE DOES NOT ILLUMINATE

1. Please check to make sure that all connectors are properly connected and

the power adapter cord is plugged into the wall outlet.

2. Turning the poles gently to make sure pole to pole are connected into place.

3. Check for loose connection between light string plugs and extension cords.

4. Please check for loose, broken or missing light bulbs and replace as needed.

LAMP REPLACEMENT

Step 1. Grasp the power adapter or power

cord plug, and then unplug from the

power outlet. Do not pull the power cord.

Step 2. Lift up lamp lock tab, then pull the lamp

and plastic lamp base straight out of

the lamp-holder.

Step 3. Replace with a new lamp.

REPAIRING LOOSE HINGES

Step 1. Place the branch into the slot of the bracket.

Step 2. Insert a new hinge pin through the holes of

the bracket and secure with a washer.

Side view

Reference figure only

Eye Bolt

*ELECTRICAL RATING FOR THE TREE

(FOR INDOOR USE ONLY)

Input: 120V, 60Hz, 0.45A

Output: 29V 0.9A

Tree Top

Section 5

Section 4

Section 3

Section 2

Section 1

Eye Bolt

Click

100S

Do Not Tamper

Internal Parts

100S

Open the

protective

cap

100S

50S

Do Not Tamper

Internal Parts

100S

Open the

50S

protective

cap

100S

50S

100S

50S

100S

Insert Green

Label Extension

Cord into Adapter

Do Not Tamper

Internal Parts

Open the

protective

cap

Adapter

to be plugged

into wall

outlet