Daytona 56687 Manuel du propriétaire et consignes de sécurité - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire et consignes de sécurité pour {nom_de_la_catégorie} Daytona 56687. Daytona 56687 4 pages.
Imprimer la page
Specifications
Important Safety Information
Failure to heed these markings may result in personal injury and/or property damage.
1. Study, understand, and follow all instructions
before operating this device.
2. Do not exceed rated capacity.
3. Use only on hard, level surfaces.
4. Center load on saddle.
5. Use as matched pair to support
one end of a vehicle only.
6. Wear ANSI-approved safety goggles and
heavy-duty work gloves during use.
7. Do not use for aircraft purposes.
8. Support vehicle only at manufacturer-
recommended locations.
9. Inspect before every use; do not
use if parts loose or damaged.
10. Examine Jack Stands for cracks or damage
before each use. Do not use if even a minor crack,
bend or other damage/deformation appears.
Discard Jack Stand if damaged or deformed.
11. Keep work area clean.
Cluttered areas invite injuries.
12. Observe work area conditions.
Keep work area well lighted.
13. Keep children away. Children must
never be allowed in the work area.
14. Store idle equipment. When not in use, tools must
be stored in a dry location to inhibit rust. Always
lock up tools and keep out of reach of children.
Assembly
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
1. Loosen the Base Screw on the Base until it
will not interfere with Sleeve installation.
2. Insert a Sleeve into the Base. Make sure it
seats completely to the bottom of the Base.
Page 2
Capacity
Height Range (Approximate) 10.4" – 15.4"
*Evenly distributed across two Jack Stands.
For technical questions, please call 1-888-866-5797.
3 Tons (6,000 lb.)*
15. There are certain applications for which this tool was
designed. Do not modify this tool and do not use this
tool for a purpose for which it was not intended.
16. Dress properly. Do not wear loose clothing or jewelry
as they can be caught in moving parts. Protective,
electrically non-conductive clothes and non-skid
footwear are recommended when working. Wear
restrictive hair covering to contain long hair.
17. Maintain tools with care. Keep tools clean for
better and safer performance. Follow instructions
for lubricating and changing accessories.
18. Stay alert. Watch what you are doing, use common
sense. Do not operate any tool when you are tired.
19. Do not operate tool if under the influence of
alcohol or drugs. Read warning labels on
prescriptions to determine if your judgment
or reflexes are impaired while taking drugs. If
there is any doubt, do not operate the tool.
20. Only use on proper surface. Only use the Jack
Stands on a dry, level, flat surface, which is free
of grease or debris. The surface to be used
must be capable of supporting the combined
weight of the vehicle and the Jack Stands.
21. The warnings, precautions, and instructions
discussed in this manual cannot cover all
possible conditions and situations that may occur.
The operator must understand that common sense
and caution are factors, which cannot be built into
this product, but must be supplied by the operator.
3. Use a wrench or socket (sold separately)
to fully tighten the Base Screw.
4. Carefully lower the Post into the Sleeve.
5. Repeat previous steps with the other Jack Stand.
Item 56687