Automatic DB 5801 Manuel d'instruction - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Automatic DB 5801. Automatic DB 5801 13 pages. 250w multi tool

Imprimer la page

Installing blade accesssories

All accessories are installed on the oscillating tool in a simi-

lar manner. For the purposes of describing the accessory

installation, the plunge cutting blade is used.

DANGER: Always remove the plug from the power

source before installing or removing accessories or

sandpaper. Failing to remove the plug from the power

source may result in the tool accidentally being started and

causing serious injury to the operator.

1. Remove the screw and washer from the

accessory holder by turning the screw

counter clockwise. Use the 6mm hex key if the

screw is too tight to be removed by hand.

2. Place the blade on the accessory holder.

Notes:

a) Make sure the alignment holes in the blade fit over the

alignment pins in the accessory holder and the printed

side of the blade is facing the tool.

b) The blade can be mounted at various angles left or right

of centre if required.

3. Thread the screw through the washer and

the blade and into the accessory holder

threaded hole.

4. Turn the screw clockwise until it is finger

tight.

Notes:

a) Check to make sure the

convex curve of the washer

is facing the head of the

screw.

b) Make sure the alignment

holes in the blade are still

mated with the alignment

pins in the accessory holder.

5. Firmly tighten the screw with the 6 mm

hex key.

Note: Check to make sure the holes in the

blade are still mated with the alignment pins

on the accessory holder after the screw is

fully tightened.