HiBoost F10G-5S-LCD Manuel de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} HiBoost F10G-5S-LCD. HiBoost F10G-5S-LCD 18 pages.

3.2 Plan the layout of your system

Before you get started you will need to plan the layout of your system. This involves

checking signal strength for signals coming from the cellular tower, as well as

antenna, booster and cable placement.

Select a location on the roof of the building to install the signal antenna, by

monitoring your cellular phone's signal strength (signal bars) to find the strongest

signal from your carrier's cellular tower.

Mark that area as the installation location for the Donor (outdoor)

IMPORTANT: Confirm that you have at least 20 feet of vertical distance between

the marked antenna location and the location where you will place the Server

(indoor) antenna. To prevent the system from oscillation (feedback) you want to

ensure that there is enough separation between the distribution and signal antenna

or that they are shielded from each other to ensure the distribution antenna does

not send a signal back into the signal antenna. If you cannot achieve these

separations, either choose an alternate location for the donor (outdoor) antenna or

determine if there are natural barriers in the building construction itself that will

attenuate signals between the two antennas so that oscillation can be prevented.

Loosely run the coaxial cable from your outdoor antenna to your booster. (After you

have tested the system you can permanently secure the coaxial cable).

As you route and pull cabling, follow these general guidelines:

Bend cables and route them smoothly, and protect the outer skin against any



damage.

Keep horizontal cables straight and fasten them with a tie every three to five



feet.

Bind and fasten vertical cables every six to eight feet.



Waterproof all outdoor connections with silicone caulking



Be careful when plugging the connector in so as not to damage the center pins



on the connectors.

Connect the supplied coaxial cable to the antenna. We recommend applying silicone

caulking to fully waterproof the connection.

Attach the cable in such a way that a drip loop is formed.

Once mounted, connect one end of the coaxial cable to the donor (outdoor) antenna

and the other end to the cellular booster where it is marked "Outdoor"

https://www.signalbooster.com/ | 1-855-846-2654 | [email protected]

6 / 20