Automatic Solutions 603STD+KPAD Manuel d'instructions d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Automatic Solutions 603STD+KPAD. Automatic Solutions 603STD+KPAD 12 pages.

Imprimer la page
This keypad has 3 outputs. The diagram below shows the LED indicators which indicate
programming and relay status information.
RED when incorrect codes entered and outputs are locked out.
1
2
3
4
5
6
7
8
9
*
0
#
TIP: After power up, as a security precaution, the keypad cannot be programmed for 60 seconds.
Once this time elapses, you may begin.
TIP: Flashing amber LED is normal standby mode!
Basic Keypad Programming
Quick start guide
1) Enter programming mode (amber LED should be ON)
0
0
0
0
2) Enter a new user code...
1
0
2
0
0
3) Exit programming mode
*
*
4) Enter the new user code to check the relay clicks.
Full Keypad programming
Enter programming mode..
0
0
0
0
Exit programming mode..
*
*
Enter a new ENGINEERS code...
Go into programming mode firstly then enter the following sequence...
0
1
?
Location
4-8 digit code
P a g e
| 7

Keypad overview

GREEN when output 1 activated.
RED when output 2 activated.
CLEAR when output 3 activated
FAST FLASHING – Wrong code entered / error.
SLOW FLASHING - in normal standby mode.
ON in programming mode.
ON when relay 3 activated.
*
*
0
?
?
?
The unit is now in programming mode. Amber LED on the
*
*
keypad should remain permanently on. 0000 is the default
programming passcode.
The unit should exit programming mode and the amber LED
should start flashing again.
?
?
?
Validate
?
#
#
Replace ???? with your new ENGINEERS
code.
Tip: The engineer code
must be the same length as
user codes. So if using a 6
digit engineers code, then
user codes must also be 6
digits long etc.