GAI-Tronics 028-02-3191-652 Manuel d'installation et d'utilisation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} GAI-Tronics 028-02-3191-652. GAI-Tronics 028-02-3191-652 20 pages. Titan illuminated crossing telephone

Imprimer la page

Installation

4.1. General

All possible measures must be taken to ensure water, fluid or dust

does not contaminate the internal components of the telephone whilst

unpacking, preparing and installing the telephone in inclement weather

conditions or by negligence.

Failure to do so may invalidate your warranty.

These telephones are supplied without connection leads – cabling to the

telephone network must be supplied and installed by the installer. Because of

this, extra precautions must be observed: installation must be carried out by

trained personnel. Contact GAI-Tronics if installation service is required.

To prepare for installation, open the door, then undo the four retaining

screws to remove the faceplate from the rear enclosure. A 3mm Allen

key is required. Take care not to damage the exposed circuit board

when setting the faceplate aside during installation.

Caution – take care to support the spring-loaded door whilst open

to prevent it slamming shut and trapping fingers.

All connections and option settings are on the rear of the faceplate

towards the lower edge.

The Titan telephone is intended for vertical installation to a wall or pole.

Select the required mounting method (section 4) and mount the rear

enclosure first where applicable.

Route the required cables through glands as appropriate, and make

connections and option settings following section 5.

Ensure that both cable entries are sealed with either a gland or a black

blanking plug as described.

Re-fit the faceplate ensuring a weatherproof seal is maintained.

Test the operation of the telephone (section 3). Installation is now

complete.

4.2. If glands are required

Before mounting the telephone, check the cable routing and requirements. If

glands are required, fit them to the case as follows:

1. Remove the RED blanking plug leaving the other (usually BLACK) in

place.

IMPORTANT

ILC-1117 Titan Illuminated Crossing Telephone