Hiboy NEX5 Manuel de l'utilisateur - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Hiboy NEX5. Hiboy NEX5 15 pages.
The Warning LED flickers the displayed value E1-E7 also flickers
Malfunction
Code
Check whether the brake taillight is on, if the brake taillight is not on, it indicates that the controller is not
Communication
E1/E7
powering the controller or instrument. If the brake taillight is on, check that the connecting cable between
Failures
the instrument and the controller are connected properly.
Check whether the brake is
Brake failure
E2
pressed
Please check if the finger is
E3
Referral Failure
pressed
Check whether the motor is
Motor Failure
E4
connected to the controller line
Controller
If the controller is damaged, replace the controller
E5
Failure
Note: Regularly check the tightness of various screw components especially the axle, folding system, steering
system and brake shaft.
Solution
If the brake is pressed release it
In case of open or short circuit,
Check the connecting cable
replace the connecting cable
between brake and instrument for
Replace brake lever
short or open circuits
If you press
Open or short circuit. Replace the
No, please check the connection
cable
line between the dial and the meter
for a short or open circuit
Change finger
No connection, connect the cable between the motor and the controller
If there is a connection, please disconnect the connecting wire and
measure whether the internal resistance between the three-phase wires
of the motor is within a reasonable range, generally within 0.1-1 ohm.
The motor needs to be replaced if it exceeds the range.
24
Common Problem & Solutions
1. The display is black
Cause: the product is subject to long-time exposure to sunlight.
Solution: keep the product in shade for some time to recover.
2. The value does not match the actual value
Cause: Parameters are set improperly or lost
Solution: Press and hold the power button to turn off and then press it again to restart the scooter
3. The displayed value is dim.
Cause: The battery is in poor contact or empty. Solution: Turn off the power supply and then turn it on again. If this problem still
occurs, contact the manufacturer or dealer.
4. lf this product does not work properly, perform the following check
a. Check power supply is turned on
b. Check the battery power level on the display
c. Check the left brake lever and rear brakes are in their original positions.
d. Check that all jacks and cables are connected correctly.
If all the steps are completed but the product is still not working properly, contact the manufacturer or dealer.
25