GAI-Tronics 352-101 Manuel - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} GAI-Tronics 352-101. GAI-Tronics 352-101 19 pages. Division 1 smart hazardous area telephones

Imprimer la page

Model 352-101, 352-102, 352-103, & 352-104 Div. 1 SMART Hazardous Area Telephones Page 12 of 17

Programming

All SMART Telephone models are programmable. The telephone settings are initially programmed

during manufacturing and testing. After the SMART Telephone is installed, you have the option of

changing the default settings. This manual provides instructions for programming basic features needed

to initially set up the telephone from another touch-tone telephone.

More advanced programming requires a PC and the TMA software. For programming using the TMA

terminal, refer to the manual provided with the software (Part No. 12509-037), or contact the GAI-

Tronics Field Service Department.

NOTE

Use a handset telephone exclusively when programming the SMART Telephone remotely. If a

speakerphone is used for programming background noise could lead to the incorrect settings. (Cellular

telephone is not recommended.)

Enter the Programming Mode

Read the entire "Programming" section and carefully plan your programming before beginning the

process. Write down the key sequence from the Command column of Table 1, Basic Programming

Commands, for the features that you need. Having your programming information written down allows

you to enter the key sequence at a steady pace.

Complete the following steps to enter the programming sequence from a remote DTMF telephone:

1. Call the SMART Telephone to be programmed. (Do not use a cellular telephone.)

2. Listen for a confirmation tone during ringing, which signals that the telephone has answered.

3. Press *** to enter the programming mode.

4. Wait two seconds.

5. Enter **0000 (0000 is the factory default maintenance PIN #.)

: After sending the maintenance PIN # to the telephone, entering *20 will allow for

OTE

confirmation of maintenance access to the telephone. If access is granted, the telephone responds

with six DTMF digits.

If access is denied, the telephone responds with two DTMF digits. If access is denied, repeat step 5 to

again request access.

6. Complete the desired programming. Refer to the "Basic Programming" section for options.

7. Listen for a confirmation tone at the end of each programming sequence, which indicates the

programming change was accepted.

NOTE

Delays during programming greater than 5 seconds cause a programming time-out. If this occurs,

you will hear a beep before the programming sequence is completed and you must reenter the

sequence.

8. When finished programming, press *99 to exit the programming mode.

f:\standard ioms - current release\42004 instr. manuals\42004-455b.doc

02/13

Pub. 42004-455B