GAI-Tronics 13351 Manuel - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} GAI-Tronics 13351. GAI-Tronics 13351 5 pages. Integral loudspeakers

Pub. 42004-164B

2 of 4

Model 13350 and 13351 Integral Loudspeakers

Page:

Wiring

Model 13350

The rear enclosure contains a two-position terminal block. Field connections are made directly on this

block. The rear enclosure of the loudspeaker allows versatile placement because it is fully "reversible"

with the front horn enclosure. The unit is shipped assembled for bottom cable entry. If top cable entry is

desired, rotate the rear enclosure 180 degrees to move the terminal block to the opposite mounting position.

The screws should be installed and tightened to 10 to 14 in-lbs. torque.

The two 3/4-inch conduit entries (female) allow speakers to be easily "daisy-chained" without junction

boxes. The installer can terminate to the speaker with rigid conduit, flexible conduit, or cable bushing. A

3/4-inch male hex socket-type conduit plug is provided when only one conduit entry is used. When conduit

entries are closed, the speaker is completely weatherproof.

After connecting the conduit to the enclosure, connect the speaker wire to the appropriate terminal blocks.

Refer to Figure 2. Then plug the "quick connect" terminals from the front section of the speaker into the

appropriate terminal blocks. Close the speaker and tighten front panel screws to 16 to 20 in-lbs. torque.

Figure 2. Model 13350 Loudspeaker Wiring

: If the conduit entries are positioned at the top of the enclosure, and hollow 3/4-inch conduit is used,

OTE

entries to the enclosure should be internally plugged using a suitable sealant to avoid condensation

collecting within the enclosure.

\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-164b.doc

2/97